Fitel S326R Instrukcja obsługi - Strona 3
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przecinak Fitel S326R. Fitel S326R 4 stron. Precision cleaver
Drukuj stronę
ATTENTION：During cleaving operation, please do not touch " Lid " and " Pinch roller lid ".
3) Open main body lid and remove the fiber from the unit.
5.2. Disposing of waste fiber
Dispose of waste fiber as follows after completion of work and before transporting the unit.
1) Grab the sides of the waste bin box with fingers and pull
it out.
2) Grasp the left and right upper corners of waste bin with
fingers and open the lid while squeezing lid lightly.
Turn waste bin box upside down and dispose of the
waste fiber into a designated trash can.
Do not put finger inside of waste bin because pieces of
the optical fiber sometimes will remain in waste box after
emptying it.
Put back waste bin box to original position after
disposing the waste fiber.
ATTENTION：When inserting waste bin box into main
body, press waste box until click is heard.
6. Blade Maintenance and Rotation of blade
The blade has 24 positions printed on the side of the blade
(i.e. "0･2･...･22･"). Each position can be used to 2,000
times. However, cleaving amount may be decreased with
dust or oil contamination. When cleaving quality degrades,
clean the top of blade and upper and lower bending pad with a cotton swab soaked with ethyl
alcohol.
If this does not help, that means it is time to rotate the
blade( see below).
ATTENTION ： Do not use Organic solvent on rubber (e.g.
Acetone).
ATTENTION：Please note 2,000 cleaves per position is
not guaranteed. The number of cleaving changes
depending on the situation and environment (e.g. dust and
oil.)
!
ATTENTION ： 0.2mm pitch ribbon fiber decrease of
cleaves.
If operation above does not improve the cleave quality, the blade needs to be rotated. Follow
the procedures below to rotate the blade.
1) Remove the waste bin from the main body. Loosen the
blade set screw using the attached hexagon ranch.
2) Use a cotton swab, etc. to rotate the blade, so that the
number shown at the top of the blade increase by one
step. (Counter clock wise) The blade is positioned at "0"
by default when manufactured in factory. The next
position is "・" right after "0".
!
ATTENTION ： Do not touch the blade directly. It is very
sharp and could cause injury.
3) Tighten the blade set screw again.
After all 24 positions are used and exhausted, the blade must be replaced by new one at
customer's expense. Contact local service center for replacing blade service.
open
Cotton swab
Direction for
rotation
Blade set screw
Hexagonal wrench