dji Matrice 600 Pro Skrócona instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Drony dji Matrice 600 Pro. dji Matrice 600 Pro 8 stron.
Również dla dji Matrice 600 Pro: Podręcznik użytkownika (16 strony), Skrócona instrukcja obsługi (9 strony)
Drukuj stronę
6. Flight
Power on the
remote controller
In the DJI GO App:
Auto Takeoff
The aircraft will take off and hover at
an altitude of 4 feet (1.2 meters).
Return-to-Home (RTH)
Bring the aircraft back to the Home
Point. Tap again to stop the procedure.
The aircraft will not avoid obstacles while it is returning to the Home Point, and an appropriate RTH altitude must be set before
●
takeoff. You should also use the control sticks to guide the aircraft. Refer to the Disclaimer and Safety Guidelines for more details.
Manual Takeoff
Combination Stick Command
to start/stop the motors
Return-to-Home (RC)
Same as the RTH button in the DJI GO app.
Brings the aircraft back to the Home Point. Press
and hold to initiate the RTH procedure. Press again
to cancel.
Rotating propellers can be dangerous. Do not start the motors when there are people nearby.
●
Never stop the motors in mid-flight, or else the aircraft will crash.
●
Always keep your hands on the remote controller so long as the motor is still spinning.
●
It is important to understand basic flight guidelines for
the safety of both you and those around you.
Refer to the Disclaimer and Safety Guidelines for more
information.
Power on the aircraft
Launch the DJI GO app
and enter Camera View
OR
DJI GO
App
Before taking off, ensure the Aircraft
Status Bar in the DJI GO app indicates
'Ready to Go (GPS)'.
Auto Landing
The aircraft will land vertically and stop
its motors.
Intelligent Flight Modes
Tap to use Point of Interest (POI),
Waypoints and more.
Left stick up (slowly)
to take off
Ready to Go (GPS)
Manual Landing
Ensure the landing gear is
lowered before landing.
Raise
Lower
Left stick down (slowly)
until you touch the
ground.
Hold a few seconds to
stop the motors.
No Fly Zones
Learn more:
http://flysafe.dji.com/no-fly