dji Matrice 600 Pro Podręcznik użytkownika - Strona 11
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Drony dji Matrice 600 Pro. dji Matrice 600 Pro 16 stron.
Również dla dji Matrice 600 Pro: Skrócona instrukcja obsługi (8 strony), Skrócona instrukcja obsługi (9 strony)
Drukuj stronę
MATRICE 600 PRO User Manual
If the power supply is not OK when powering on the batteries, the DJI GO app will either prompt you
to adjust the battery positions or tell you there is a large voltage difference.
To adjust the battery positions:
1. Power off all the batteries.
2. Adjust battery positions by following the tips in the DJI GO app.
3. Ensure all the battery positions are correct and then power on one of the batteries. The other
batteries will power on automatically if the positions are correct.
If the message prompt says there is a large voltage difference, the power supply issue cannot be
resolved by adjusting the battery positions. Fully charge all the batteries and try again.
Powering Off: Press the Power Button once, then press again and hold for 2 seconds to power off.
Ensure that all Intelligent Flight Batteries are operating normally before takeoff. If a battery
abnormal status appears in the DJI GO app, follow the on-screen instructions. The DJI GO
app will instruct you to land if a battery abnormality occurs during flight. In this event, you
should land and check the battery immediately.
Low Temperature Notice
1. Using the Intelligent Flight Battery at core temperatures below -10℃ is not advised. Between -10℃
and 5℃, the Intelligent Flight Battery should attain a voltage of 4.2 V, but it is recommended that
you apply the insulation sticker to the battery to prevent a rapid drop in temperature.
2. In cold environments (i.e. air temperature below 5℃), the performance of the Intelligent Flight
Battery is reduced. Ensure the Intelligent Flight Battery is fully charged and attains a voltage of 4.35
V before takeoff.
3. In very cold environments (e.g. air temperature of -20℃, battery core temperature of 5℃), the
Intelligent Flight Battery's core temperature will drop rapidly even after pre-heating, and its
performance is significantly reduced. It is not recommended to fly under such conditions.
4. If the DJI GO app displays the Low Battery Level warning, stop flying and land the aircraft
immediately. You will still be able to control the aircraft's movement when this warning is triggered.
5. For the optimal performance, maintain the Intelligent Flight Battery's core temperature above 20℃
when in use.
Ensure the temperature of the Intelligent Flight Battery exceeds 5℃ before takeoff.
To warm up the battery, power on the Intelligent Flight Battery inside the battery compartment,
for approximately 1-2 minutes, before takeoff. Begin flying by hovering the aircraft at a low
altitude, for approximately 1 minute, to ensure the battery temperature is stable.
Checking the Battery Level
The Battery Level Indicator shows how much battery capacity is remaining. When the battery is
powered off, press the power button once. The Battery Level Indicator will light up to display the
current battery level. See the table below for details.
The Battery Level Indicator will show the current battery level during charging and discharging.
Its LEDs can exhibit the following behavior.
: LED is on.
: LED is off.
10
©
2016 DJI All Rights Reserved.
: LED is blinking.