ARTHUR HOLM AH15D1HGA Podręcznik użytkownika - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Monitor ARTHUR HOLM AH15D1HGA. ARTHUR HOLM AH15D1HGA 14 stron. Hdcp compliant motorised monitors for furniture integration

Drukuj stronę

1. Input Connectors

CONTROLS

Remote control

POWER

Switch ON/OFF the monitor

Activates the OSD menu on screen

Cursor control up on the OSD menu

DOWN

Cursor control down on the OSD menu

LEFT

Cursor control left on the OSD menu

RIGHT

Cursor control right on the OSD menu

Selects the function on the OSD menu. When the OSD

menu is not active on screen, selects the input source

Monitor address

Below the monitor, there is a screen to set-up the monitor. Press the UP

or DOWN buttons to change the function. Press the OK button to select

the function. Change the parameter using the UP or DOWN buttons

and press OK to save the changes.

AHNET ID

Selects the number AHnet ID to RS422 to externally

control the monitor

INPUT SELECT

Selects the input source signal (DVIA, DVI1 or DVI2)

BRIGHTNESS

Configuration of the monitor brightness level

CONTRAST

Configuration of the monitor contrast level

BACKLIGHT

Configuration of the monitor backlight level

STATUS INFORMATION List of the monitor status to service

CONTROLS

IR sensor

The IR sensor is located on the lower right side of the screen.

Monitor movement controls

On the upper cover plate, there are three buttons to control the UP and

DOWN monitor movements.

1. Closing the monitor:

Press the top button (1) to completely fold the monitor. The monitor

will slowly fold. To adjust the angle, permanent press this button

(1) and release it when the screen is at the desired working angle.

Please, make sure that there are no objects, which could obstruct

the folding of the display.

2. Memory button:

Press the middle button (2) to raise the display at the memorised

position. In order to memorise a position, use buttons 1 and 3, to

position the screen at the desired tilt angle (permanent press the

UP & DOWN buttons and release it when the screen is at the desired

position). To save or store the position, press and hold the middle

button (2) for 3 seconds (the sound of a "beep" will indicate that

the desired position has been saved). Please, make sure that there

are no objects, which could obstruct the folding of the display.

3. Opening the monitor:

Press the bottom button (3) to raise the display at the maximum

angle. Permanent press this button to slowly raise the monitor and

release it when the desired position is reached. Please, make sure

that there are no objects, which could obstruct the raising of the

display.

1. CONTROL DOWN BUTTON

2. MEMORY POSITION BUTTON

3. CONTROL UP BUTTON