dji PHANTOM 3 PROFESSIONAL Skrócona instrukcja obsługi - Strona 9

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Drony dji PHANTOM 3 PROFESSIONAL. dji PHANTOM 3 PROFESSIONAL 10 stron. Intelligent flight battery heater
Również dla dji PHANTOM 3 PROFESSIONAL: Skrócona instrukcja obsługi (8 strony), Podręcznik użytkownika (3 strony), Skrócona instrukcja obsługi (4 strony), Podręcznik zaawansowany (16 strony)

Drukuj stronę

dji PHANTOM 3 PROFESSIONAL Skrócona instrukcja obsługi

●

Manual Takeoff and Landing (Stick configurations are for MODE 2)：

Start the motors by pulling both control sticks to the bottom

inside (or outside) corners. Release the sticks once the

motors start. Slowly push the left stick (throttle stick) up to

takeoff.

Start / Stop the motors

Never stop the motors mid-flight, otherwise the aircraft will crash. Only stop the motors when on the ground or as required in

●

emergency situations to reduce the risk of damage or injury.

You cannot takeoff if the Intelligent Flight Battery is not sufficiently charged and the Critical Low Battery Warning is active.

●

The Intelligent Flight Battery must warm up if the outside temperature is low. A warning will appear in the DJI GO app in this scenario.

●

Once spinning, the rotating propellers can be dangerous. Do not start the motors when there are people nearby and always fly

●

in a wide-open area.

Power off your Phantom 3 Professional before switching off the Remote Controller after landing.

●

Return to Home：

1. Press and hold the Return to Home Button on your

Remote Controller until the LED surrounding the button

starts blinking white and starts beeping. Your Phantom

3 Professional will return to the set Home Point. Press

the button once to stop the procedure.

RTH Button

The app's RTH Button

Appendix

Aircraft Status Indicators

Slowly: Safe to fly, GPS working

Continuously: Vision Positioning

system working, no GPS

Slowly: P-ATTI or ATTI Mode

Quickly: Not connected

to the Remote Controller

Slowly: Low Battery Level Warning

Quickly: Critical Low Battery Level Warning

Solid: Critical error

Blinking Alternately:

Compass calibration required

For more information:

http://www.dji.com/phantom3

Left stick up (Slowly)

2. The DJI GO app will warn you if your Phantom 3

Professional's battery level falls under a certain level. This

warning threshold can be set in the app. The aircraft will

land immediately if the battery power reaches a critical

level and the Critical Low Battery Level Warning appears.

3. Failsafe: The Phantom 3 Professional will enter Return to

Home Mode if the signal to the Remote Controller is lost.

●

Remote Controller Status LED

Remote Controller is functioning normally,

but is not connected to the aircraft.

Remote Controller is functioning normally

and is connected to the aircraft.

B-B-B

Aircraft Low Battery Level Warning

...

or Remote Controller error.

Remote Controller has been

B—B—...

idle for 5 minutes.

To land, gently pull the left stick (throttle stick)

down to lower the aircraft until it touches the

ground. Then pull both sticks to the bottom inside

corners to stop the motors.

Left stick down (Slowly)

While returning home, you can still control your Phantom 3

Professional's altitude to avoid any obstacles.

Camera Controls

Adjust the camera parameters using

●

the Camera Settings Dial on the

Remote Controller or through the DJI

GO app. Press the Shutter Button or

Video Recording Button to capture

photos or record videos.

Adjust the gimbal's tilt using the

●

Gimbal Dial.

Download photos and videos from

●

the Micro SD card to your mobile

device through the DJI GO app.

You can also use a SD-card reader

to export files to your computer.