dji Inspire 1 Pro Skrócona instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Quadcoptery dji Inspire 1 Pro. dji Inspire 1 Pro 10 stron.
Również dla dji Inspire 1 Pro: Skrócona instrukcja obsługi (11 strony), Skrócona instrukcja obsługi (11 strony), Podręcznik użytkownika (10 strony)
Drukuj stronę
near or above people, near
trees, power lines or buildings.
in rain, snow, fog, and wind
speeds exceeding 22 mph or 10 m/s.
Be very careful when flying 14,700 feet (4,500 meters) or more above sea level as the battery and aircraft performance may be reduced.
Make sure to calibrate the compass in every new flight location. The compass is very sensitive to electromagnetic interference,
which can cause abnormal compass data leading to poor flight performance or even failure. Regular calibration is required for
optimum performance.
structures, and steel reinforcements underground.
If it is blinking red and yellow alternately after placing the aircraft on the ground, the compass has detected magnetic
interference. Change your location.
the VPS allowing it to hover accurately in position indoors and out.
If outdoors, this mode also means that a Home Point has been
locked so that it can Return to Home if the control signal is lost.
If you are not in this mode, toggle the Flight Mode
Switch to P position to enable it.
The Flight Mode Switch is locked in P mode by default.
Refer to the User Manual on how to unlock the switch.
There are three states in P mode.
P-GPS:
signal is strong. P-OPTI:
use the VPS to hover accurately. P-ATTI:
available, aircraft is using only its barometer for positioning, so only
when the Inspire 1 Pro is flying over water, over surfaces without a
clear pattern, or in a low light environment.
The aircraft cannot avoid obstacles during the Failsafe RTH, but user can regain control of the aircraft when signal transmission is resumed;
therefore it is important to set an appropriate Failsafe altitude before each flight. Be sure fly higher than any tall buildings to avoid crashing.
400 ft
Always
fly under
and fly under 400 feet
(120 meters).
and avoid flying behind buildings
or obstacles that block your view.
able to record a Home Point and return to the Home
yellow or green.
The aircraft will return to the Home Point automatically in
Smart RTH: When you press the RTH button on the
remote controller or in the App. Low Battery RTH: The
battery level falls to a specified threshold.
Failsafe RTH: When the remote controller signal is lost.
It is important to understand basic
flight guidelines, for the safety of
both you and those around you.
Disclaimer for more information.
More information at:
http://flysafe.dji.com/no-fly