ARTHUR HOLM AHDTLM UC Podręcznik użytkownika - Strona 9

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Mikrofon ARTHUR HOLM AHDTLM UC. ARTHUR HOLM AHDTLM UC 16 stron. Motorized microphone system for underneath installation

Drukuj stronę

Settings: 6 dip switch to configure the DynamicTalk.

Dip switch

Function

1,2,3

ON: DynamicTalk configured as PA mode. The Talk push

button controls the microphone mute function

OFF: DynamicTalk configured as conference mode. The

talk push button has no function but the contact close is

present on GPO connector and the ring LED is externally

controlled

4, 5

Only factory. Leave those dip switches off

Termination of the RS422 bus. Configure to ON only in

the last device of the RS422 bus

AHnet: RJ45 CAT5 connector for addressable RS422 control. There is a

loop through connector to use as signal RS422 output. You can

connect up to 30 units on the same RS422 bus

AHnet ADDRESS: Using the AHnet protocol, this is the number of the

device into the RS422 addressable bus

Microphone length setting procedure.

Dynamic Talk is designed to work with microphones of different lengths.

Two signs to identify an incorrect setup of the microphone length are:

•The microphone do not goes down completely.

•The microphone goes down too low, and gets stucked inside. The

microphone length can be adjusted using Monitor Configurator Tool, but

there is a quick procedure not requiring the PC and the cabling

PROCESS

1. Disconnect Power connector

2. Set switch 5 to ON position

3. Set the length of the microphone in the rotatory

switch, in cm. For instance, if the microphone is

40cm, set the rotatory switch as: tens=4, unit=0)

4. Connect Power , there will be a 5 beep sound

5. Disconnect Power

6. Set switch 5 to OFF position

7. Set the AHnet address in the rotatory switch,

the default setting is address 01 (tens=0, units=1).

8. Connect Power connector