EDILGRAPPA MU 22N Instrukcje użytkowania i konserwacji - Strona 17

Przeglądaj online lub pobierz pdf Instrukcje użytkowania i konserwacji dla Elektronarzędzie EDILGRAPPA MU 22N. EDILGRAPPA MU 22N 20 stron. Machine body with interchangeable heads

Drukuj stronę

5 STORAGE AND RESTARTING

5.01 STORAGE

In case of long periods of inactivity, proceed as follows:

5.01.01 ELECTRIC MOTOR

- Clean all the internal electrical parts (rotor, stator, cooling circuit) with compressed air

DO NOT USE CONDUCTIVE OR FLAMMABLE LIQUIDS TO CLEAN INTERNAL

ELECTRICAL PARTS

- To clean the outside of the machine, if necessary, use a cloth dampened in soapy

water and then dry thoroughly

- Check the following are in good condition:

• insulation

• power cable

• switches

• plug

• brushes and manifold

• clean the stator, rotor, cooling circuit and fan with compressed air

5.01.02 CYLINDER AND HYDRAULIC COMPONENTS

Before performing these operations, see the relative instructions in Chap. 3

· Check the hydraulic oil and top up or, if necessary, replace.

· Clean the magnetic cap and check the membrane.

· Check for any oil leaks.

· Tighten the screws.

Store the tool in a dry place that can only be accessed by authorised staff.

5.02 RESTARTING

Before performing these operations, see the relative instructions in Chap. 3

- Check the oil tank is full and top up if necessary

- Remove any traces of oil remaining after topping up or applied to protect metal parts

from the grip and other parts that can be gripped.

ELECTRIC MOTOR

- Ensure that the power cable, the plug and the machine body have not been damaged.

- Start the machine a few times and make sure no operating faults occur.

ELIMINATE ANY FAULTS BEFORE STARTING WORK.

MU 22N