dji OSMO Skrócona instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Akcesoria do kamer dji OSMO. dji OSMO 2 stron. Gimbal extension
Również dla dji OSMO: Skrócona instrukcja obsługi (11 strony), Instrukcja obsługi (6 strony), Skrócona instrukcja obsługi (5 strony), Skrócona instrukcja obsługi (4 strony), Podręcznik użytkownika (8 strony)

Drukuj stronę

Install the DJI GO App

Search for 'DJI GO' on the App Store or Google

Play, and install the app on your mobile device.

OSMO

DJI GO supports iOS 8.0 (or later) or

●

www.dji.com

Android 4.1.2 (or later).

Prepare the Battery

Fully charge the battery for the first time to activate.

Insert the battery as shown.

Charge Time: ~1 hour.

●

The LED indicator will glow green when

●

charging is complete.

Mount your Mobile Device

Unfold the clamps

Adjust the pads

Place one end

Pull outwards

Rotate to desired angle

Battery Level

High Low

Ensure your mobile device is fully seated.

●

Unlock the Gimbal

1. Rotate the tilt motor

2. Rotate the roll motor

3. Slide the Pan Axis Lock up

Follow the order above to avoid damaging the camera.

●

Rotate the motors just enough to loosen them.

●

Place the other end

Connect to the DJI GO App

To Power On:

Pull down on the switch

Pull down again > Sleep

Pull down and hold for 1.5 s > Power Off

Turn on your mobile's WiFi and

connect to

Default password:

OSMO_XXXXXX

Launch the app and tap

DJI GO

Enter Camera View.

App

Activate the Osmo if you are using it for the first

time. This requires an internet connection.

Internet

Controls

●

Position the camera

●

directly by hand.

Record Button

●

Press once to start recording,

and again to stop recording.

Shutter Button

●

Press once to take a photo.

Trigger

●

Hold down to enable Lock Mode.

Tap twice to center the camera.

Tap three times to enter Selfie

Mode.

SmoothTrack Mode is enabled automatically to

●

smooth out jerky movements.

The Osmo will beep slowly if the gimbal is

●

locked after it is turned on. This means the

camera is working normally but the gimbal is

shut off.

If you need to unlock the gimbal after it is

●

OSMO_XXXXXX

turned on, you must rotate the pan motor after

12341234

unlocking the tilt motor and pan motor to

reactivate the gimbal.

For more information, read the User Manual:

www.dji.com/product/osmo

※This Quick Start Guide is subject to

change without prior notice.

Pan or tilt the camera with

the joystick.