FITNESS AUDIO DX6 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odbiornik FITNESS AUDIO DX6. FITNESS AUDIO DX6 12 stron. Single-channel three redundancy digital receiver

Drukuj stronę

DX6-PR

Single-Channel Three Redundancy Digital Receiver

Signal Indicator

SOLID GREEN: The receiver is paired and

communicating with the transmitter.

Volume Control

Use the the plus (+) / minus (-) button to increase / decrease the microphone output gain level.

A change in line level will also correspond with the change in microphone output gain level.

The volume control has a total of 11 increments. Each time the unit is powered on it will start at

the default volume setting. There are 4 increments of volume increase available above the

default level and 6 increments of volume decrease available below the default level.

Internal battery and charging

The receiver has an internal lithium-ion rechargeable battery. It charges via the mini

USB port located at the bottom. For charging, plug the mini end of the USB cable

into the receiver's charging port and

A. plug the USB-A end into the included AC adapter (to be plugged into a power

socket).

B. plug the USB-A end into a computer USB port or power bank.

While the RX is charging, the power indicator

light will flash GREEN.

Reset button

The receiver has a recessed reset button located on the back. The reset button acts

as a backup to the power button's "off" function. In case the RX's power button is

unresponsive, the reset button can be used to power it off. To use the reset button,

the unit must be powered on. Press the reset button by using a thin, rigid object like a paper clip

or tip of a pen; push and hold for 1 second and then release. The unit will power off and need to

be turned on again.

min

▼

FLASHING GREEN: the receiver is not

connected to the transmitter, or has gone out of

range. If this light remains blinking, the units will

have to be paired again. See detailed

instructions on pairing on P.4.

default

max

▼

10 11

This light will turn off to let you know charging is

complete. The full charge time is approximately

2.5 hours. It is also possible to operate the

receiver while being charged.