Artic Breeze AB-3052 Instrukcja instalacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wentylator Artic Breeze AB-3052. Artic Breeze AB-3052 2 stron. Retrofit-style solar fan
Building the Mounting Box
Begin by building a mounting box around your existing
gable or passive vent inside the attic. Measure the length
between the studs adjoining the vent and cut the 2x4
boards to complete the box as shown in Figure 2. Secure
the boards in place using woodscrews.
NOTE: Mounting box should be no larger than 21"x21".
If gable or passive vent extends beyond this area,
block off excess venting area to prevent backflow
of exhaust air.
When completed, the mounting box should provide an air
channel for the gable fan to properly exhaust through.
Installing the Fan Unit
Next, install the Attic Breeze retrofit-style solar fan flush to
the mounting box (see Figure 3). The fan housing
(cylinder) should be positioned facing toward the attic
space. Secure the fan unit to the mounting box with self
tapping screws.
Routing the Power Cable
Locate the power cable include with your Attic Breeze
solar attic fan. Make sure the power cable is long enough
to reach the location where the remote solar panel will be
installed.
NOTE: If additional power cable length is needed for your
installation, Attic Breeze offers a 40 foot extended
power cable as an available option.
Next, plug the power cable into the power cable connector located on the fan unit. If installing a Breeze
Mate
®
control system, first plug the Breeze Mate
the power cable into the Breeze Mate
NOTE: If installing a 40W solar attic fan, plug the power cable splitter into the power cable connector
located on the fan unit and then connect the two power cables to the splitter. For Breeze Mate
installations, the power cable splitter must be plugged into the Breeze Mate
Route the power cable through the attic, starting from the fan unit to the location where your remote solar
panel will be installed. Secure the power cable in place. The power cable may be routed out of the attic by
bringing the cable through an existing passive vent, penetrating a gable wall and running the cable along the
roof eve, or simply routing the power cable directly through the roof. When making any wall or roof
penetration, caulk around the penetration using a roof-grade weatherproof sealant.
Solar Panel Mounting
Install the solar panel mounting brackets per the instructions included with your specific Attic Breeze bracket
kit. Plug in the power cord to the connector on back of the remote solar panel. Securely mount the solar
panel as required to your roof or structure.
®
cable into the fan's control cable connector, and then plug
controller per the instructions included with that product.
®
www.atticbreeze.net
Copyright © 2015 Attic Breeze, LLC. All rights reserved.
Figure 2 - Building the Mounting Box
Figure 3 - Mounting the Fan Unit
controller.
®
®