dji Zenmuse H2-2D Podręcznik użytkownika - Strona 8
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Akcesoria do kamer dji Zenmuse H2-2D. dji Zenmuse H2-2D 16 stron.
Drukuj stronę
Autopilot System, GCU and Gimbal Wiring
GCU Port Description
Gimbal Controller Unit (GCU)
3S~6S
To the battery. Power for the GCU and gimbal.
G8
To Gimbal, transmitting the signal.
Micro-USB port: PC connection for configuration and firmware upgrades.
CAN-Bus port: Use a CAN-Bus cable to connect the GCU to the autopilot system.
To Wireless Video Transmission Module, transmitting the Video signal.
Mount the GCU horizontally or vertically on the aircraft.
STEP1.
Connect GCU and Autopilot System
STEP2.
Carry out the following procedures to finish the connection.
1.
Keep the Autopilot system in the same state as it was, and upgrade the Main Controller to the latest
Firmware (shown as the following table).
Assistant Software
Firmware Version
2.
Connect the Autopilot System (shown as the following table). For NAZA-M user, you are asked to prepare a
PMU V2 module (Accessory of NAZA-M V2) and do some reconnection of the system.
(1) Main Controller and PMU
connection
(2)PMU Power Cable
connection
(3)
GPS/Compass module and
Autopilot system connection
Please refer to the following diagrams for more GCU connection details. And refer to the Autopilot system manual
for more connection and configuration details.
3.
Connect the GCU to Autopilot System. And then connect the 8-Pin cable of gimbal to the G8 port of GCU.
(1)
GCU and Autopilot System
©2013 DJI Innovations. All Rights Reserved.
Port Description
WKM
V2.00(or above)
V5.22(or above)
Connect the X1 port of PMU to X1
port of Main Controller.
Connect the
Power Cable
Connect the GPS/Compass module
to any spare CAN-Bus port on PMU.
Connect the GCU to any spare
NAZA-M V2
V2.12(or above)
V3.12(or above)
WKM
to a connecter, if DJI Multi-rotor is used, solder the
power cable to the power pad on aircraft.
WKM
NAZA-M
V2.12(or above)
V3.12(or above)
NAZA-M V2
NAZA-M
Connect the X3 port of PMU V2 to
X3 port of Main Controller.
Connect the GPS/Compass module
to the GPS port of PMU V2.
NAZA-M V2
NAZA-M
Connect the GCU to the CAN-Bus
8