djpower TOPCAT H-X3 DMX Podręcznik użytkownika - Strona 3
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Kostkarka do lodu djpower TOPCAT H-X3 DMX. djpower TOPCAT H-X3 DMX 13 stron. Automatic dry ice machine
Drukuj stronę•
Do not store dry ice in a sealed container to avoid explosion due to accumulated pressure.
•
Do not cover or block the nozzle during operation to avoid explosion due to accumulated pressure.。
•
Be sure to wear protective gloves and do not directly touch dry ice with bare hands.
•
Do not swallow dry ice, this can lead to severe internal injuries.
•
When breaking solid blocks of dry ice, always use eye protection. Cover the dry ice with a piece of cloth or put the dry ice in
a cloth bag to prevent fragments from flying
•
Do not use the device in a confined space. Before using the device, ensure that the space is well ventilated.
1.5.2
Personal Safety
•
Always connect the product to a grounded circuit to avoid the risk of electrocution.
•
Make sure that children, unauthorized people and animals do not obtain access to the machine.
•
During the heating or operation of the machine, the temperature of the water tank is high, please do not touch it.
•
Do not touch the hot nozzle of the machine during operation. The distance between the machine and the nearest object
should be at least 2 meters.
•
Before cleaning, disconnect the machine from the power supply.
•
Before transporting the machine, empty the water tank through the drain valve.
1.5.3
Mounting and Rigging
•
For safety reasons, other installation methods are not recommended, please install and operate the machine in a flat position.
•
Please keep the machine dry. Do not expose the machine to rain or moisture. Do not use the machine when it is wet, wipe
with a dry cloth.
•
CAUTION: When transferring product from extreme temperature environments, (e.g. cold truck to warm humid ballroom)
condensation may form on the internal electronics of the product. To avoid causing a failure, allow product to fully acclimate
to the surrounding environment before connecting it to power.
•
Do not mount the product on a flammable surface (linoleum, carpet, wood, paper, carton, plastic, etc.).
•
Do not use the unit in a confined space. Always install the product in a location with adequate ventilation, at least 20 in (50
cm) from adjacent surfaces.
1.5.4
Power and Wiring
•
Always make sure that the voltage of the outlet to which you are connecting the product is within the range stated on the
decal or rear panel of the product.。
•
Make sure the power cord is not crimped or damaged.
•
Do not connect the machine to the dimming controller or rheostat.
•
Never disconnect the product from power cord by pulling or tugging on the cord.
•
To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely disconnect the product from
power via breaker or by unplugging it.
1.5.5
Operation
•
Do not operate this product if you see damage to the housing or cables. Have the damaged parts replaced by an authorized
technician at once.
•
During the operation, the area in front of the nozzle will get wet, please be careful to avoid slipping.
- 2 -