Custom Dynamics GEN-SMART-TPU -IND Instrukcje instalacji - Strona 2
Przeglądaj online lub pobierz pdf Instrukcje instalacji dla Akcesoria motocyklowe Custom Dynamics GEN-SMART-TPU -IND. Custom Dynamics GEN-SMART-TPU -IND 4 stron.
Drukuj stronę
1
3
5.
Locate the two switches and rotary dial. Be sure the rotary dial is set
to position 0. There is small arrow on the dial, this is the pointer that
should now be at position 0. Be sure Switch 1 and Switch 2 are both
in the ON position. (See Module Controls Diagram)
6.
Turn the ignition key on and check operation as follows:
•
Running Lights: Turn Signals and Taillight are now illuminated dimly.
•
Apply Right Turn Signal and check operation of right turn signal,
should flash off to bright. Disable turn.
•
Apply Left Turn Signal and check operation of left turn signal, should
flash off to bright. Disable turn.
•
Apply Brake Light. Check to see that all 3 lights flash 4 times then
remain bright.
•
Apply Left Turn Signal then Apply Brake, Check to see that Only Cen-
ter Light Flashes 4 times then remains bright.
Questions? Call us at: 1 (800) 382-1388
Installation Instructions - Page 2
2
M-TH 8:30AM-5:30PM / FR 9:30AM-5:30PM EST
On On
1
2
Rotary
Off Off
Diagram - Module Controls
04/2019