3KO Apollo Micro-2 Podręcznik - Strona 3
Przeglądaj online lub pobierz pdf Podręcznik dla Pager 3KO Apollo Micro-2. 3KO Apollo Micro-2 4 stron. Gsm pager/remote control
Drukuj stronęwww.3ko.hu
5. digit
6. digit
Blevel (3 decimal digit: 080-300, if the record is missing then function is deleted)
Low battery SMS voltage threshold, example: for 9,5V enter 095, for 13,2V enter 132. ("Supply" SMS will send to Altel1.)
Cl... (Example: ClRoland, ClGloria)
The data related to these keywords are the phone numbers, from which the remote contol of relay is permitted.
The special setup parameters of control functions will be defined at keyword Bitset. If voice acknowledge was set, then three beep
will be the answer for a Swith-On, and one beep for a Switch-OFF. Also one beep will be the ACK for any change if the relay was set
to monostable operation. After receiving the acknowledge the connection could be broken.
Dtmfseq
The data related to this optional keyword is a numeric string of 15 digits, which will be sent by pager in form of DTMF tones when a
paging is successful (the target picks up the line). After finishing the message the pager will break the connection.
If this keyword is not recorded, then in case of successful paging the pager will break the line immediately after the target was
picking up the line.
Fwdsms
The data related to this keyword is the phone number where the incoming SMS messages will be forwarded to. This function is not
recommended, because forwarding of SPAM SMS or other special SMS can generate bigger cost for the users.
Newcall
(5-240 min, if the record is missing then default is 10 min)
The data related to this keyword is the new call delay time in minutes (the time between two consecutive new calls), the pager waiting
after a triggering before accepting a new event from the negative input line and starting a new call to the target number. This
parameter could disclose the undesirable input repetitions (prelling) and successive calls.
Newsms
(5-240 min, if the record is missing then default is 30 min)
The data related to this keyword is the new sms delay time in minutes (the time between two consecutive SMS), the pager waiting
after a triggering before accepting a new event from the negative or positive input lines and sending a new sms to the target number.
This parameter could disclose the undesirable input repetitions (prelling) and successive SMS messages. If we set the restore option
for positive input (i.e. the pager have to send SMS upon restoring as well) then this delay is valid also for those messages.
Newtest
(10-250 hour, if the record is missing then function is deleted)
The data related to this keyword is the periodic test-time interval in hours. ("Test message" SMS will send to Altel1.)
Possms
The data related to this keyword is the phone number where the predefined text SMS messages will be sent to, when the positive input
was triggered. The first predefined SMS will be sent.
Psw
The data related to this keyword is a numeric string of 4 digit password, used for identification when sending remote control SMS
commands to the pager. The 5-digit SMS message, beginning with this password will be accepted by module as a valid command, and
the last digit will be interpreted as follows:
0: Relay switch-OFF
1: Relay switch-ON
2: Restart GSM-module (security function in case of breakdown)
Apollo micro-2 V6.04
1 – in case of SMS command to relay control, the module will not pick up the line
0 – restore of positive input will not generate message
1 – restore of positive input will generate an SMS message (third SMS)
0 – the module dials all Altel phone numbers
1 – the module dials up to the first number picking up the line.