Artison Sketch LCR DualMono MK 2 Skrócona instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Głośniki Artison Sketch LCR DualMono MK 2. Artison Sketch LCR DualMono MK 2 4 stron.
Również dla Artison Sketch LCR DualMono MK 2: Instrukcja instalacji (16 strony), Skrócona instrukcja obsługi (4 strony), Instrukcja instalacji (4 strony)
Drukuj stronę
Fine Tune Speakers
To fine tune the A/V Receiver/Processor, set using the follow-
ing:
– Set Speaker to SMALL
– Set Crossover Frequencies
•
Dual Center = 80 Hz
•
Left and Right = 80 Hz
– Crossover Slope = 18 dB/octave or greater.
Install Blackout Foam to Grilles
Included with each grille is a sheet of blackout foam. When
the grille mesh is are larger than the speaker, this foam should
be installed to the backside of the mesh on top and bottom to
blackout any light from showing through the grille.
1. With scissors or similar, cut the foam to the correct size to
cover any mesh that may let light show through the top
and bottom of speaker.
2. Peel off the adhesive sheet.
3. Position the sheet with the adhesive facing the backside of
speaker and install to both the top and bottom of speaker.
See diagram below.
Mount Grilles
1. Position the tabs on the grille so they line up with the four
slots in each corner on the face of the speaker enclosure.
2. Apply with an inward pressure on each of the corners until
grille is set into position.
HELPFUL! The slots in the speakers are roughly
longer than the tabs in the grilles. When installing, ad-
just the grille up or down to align it with the TV before
pressing into position.
P-LCRDM-MK2 | 009-1626-00 | 181113
Copyright 2018 Savant Systems, LLC
Blackout Foam
Backside
View of
Grille
Blackout Foam
1/4
inch
Custom Grilles
If grilles for your speakers have not already been ordered, an
online tool is available to assist you to custom design grilles
that fit your exact TV. Once designed, the custom designed
grilles can then be ordered. To access the Grille Designer tool,
go to
www.savant.com
25.3 in.
(64.26 cm)
NOTE: Grilles will add .3 in. (.76 cm) to the
overall depth of the speaker assembly.
4
of
4
and select the Store tab.
6.20 in.
(15.75 cm)
Includes
Bracket
2.0 in.
(5.08 cm)
13.625 in.
(34.61 cm)
2.5 in.
(6.35 cm)
2231 Meridian Blvd #1, Minden Nevada 89423
www.savant.com/artisonspeakers
26.4 in.
(66.94 cm)
| 775.783.4770