DK-TEC SPCPR150 Podręcznik użytkownika - Strona 6
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Chipper DK-TEC SPCPR150. DK-TEC SPCPR150 12 stron. 15 hp wood chipper with electric start
Drukuj stronę•
A jammed piece of wood in the inlet pipe can only be safely removed when the engine is
switched off. If necessary, open and tip the inlet and outlet tubes to facilitate access to the
rotor. Use a wooden stick to remove the jammed piece of wood in the rotor. Never use your
hands! (Fig. 5-8)
•
Never leave the machine unattended.
•
Changing the rotor blades or counter blades and checking the blade bolts should only be
done when the engine and rotor are turned off, the spark plug cap is removed, and the rotor
is blocked.
•
After an hour of use, always check that all bolts and nuts are still tightened correctly. If not,
tighten them again or take the machine to a service workshop.
•
Use only original spare parts to maintain your file shredder, otherwise the warranty will be void.
•
The chipper may only be repaired by a qualified service workshop.
•
The chipper exceeds 90 dBA during operation. Therefore, all users and spectators
must wear hearing protection.
•
Before use, ensure that the bolts on the fixed blade and other bolts are tight. Check after
an hour that the bolts are still tight (This is only done the first time). But thereafter regularly
– damage due to lack of re-tensioning and maintenance will void the warranty.
Foldable handle
The chipper's handle for manual transport can be folded for easier transport. This is done by
removing the 2 pins on the handle, after which the handle can be folded. Reinsert the 2 pins to
ensure that the handle does not move during transport.
01/2020
4