DK2 Power OPC503 Instrukcja montażu - Strona 14
Przeglądaj online lub pobierz pdf Instrukcja montażu dla Niszczarka do papieru DK2 Power OPC503. DK2 Power OPC503 15 stron. Chipper shredder top loading
Również dla DK2 Power OPC503: Instrukcja montażu (13 strony), Instrukcja obsługi (14 strony), Instrukcja instalacji (20 strony)
Drukuj stronę
QUICK START AND TROUBLE SHOOTING GUIDE
QUICK START SETUP
•
ADD 10W30 OIL TO ENGINE
•
ADD GAS
•
PIN BOTH WHEELS INTO PIVOT BRAKE HOLES.
•
TURN KEY ON
•
HALF THROTTLE (CHOKE OPTIONAL FOR COLD STARTS)
•
SET THROTTLE TO JUST OVER TURTLE
•
PULL START THE ENGINE
TREE CHIPPING
•
ENGINE ON HIGHEST SPEED
•
FEED SMALLER TREES INTO CHUTE AND LET GO, TREE WILL AUTO FEED.
•
FEED LARGER TREES SLOWLY ALLOW CUTTER WHEEL TO REGAIN RPM SPEED
BETWEEN CUTS.
•
FEED LEAVES, TWIGS AND UPTO 3/8 INCH DIA TREES INTO TOP HOPPER.
TROUBLE SHOOTING
• ENGINE WONT START
•
TURN KEY ON – CHECK ENGINE OIL LEVEL - CHECK GAS LEVEL
•
FOLLOW YOUR ENGINE MANUAL FOR FURTHER TROUBLE SHOOTING.
• UNIT VIBRATES
•
CHECK YOUR CHIPPER FOR MISSING OR LOOSE BLADES.
•
CHECK YOUR CHIPPER WHEEL IS NOT OBSTRUCTED AND FREELY TURNS.