Altwork Station Skrócona instrukcja obsługi - Strona 11
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Wyposażenie wnętrz Altwork Station. Altwork Station 11 stron.
Drukuj stronęThe new way to work.
FAQs & Warnings
Items
Comments
Cable/Wire
All routed wires should allow adequate slack loops at rotating joints to prevent wire
Routing
stretching or chaffing. Any chaffed wires should be removed from service immediately.
Covers
Do not push fingers through any openings, slots or holes in the protective plastic covers.
Fingers could be cut or pinched by internal mechanisms.
Horizontal
The fore-aft monitor adjustment should be moderately hand tightened after moving the
Monitor Mount
monitor to prevent the monitor from falling toward the user when the Station is reclined
Monitor
Monitor should be installed by a qualified technician and all mounting screws fully tightened.
Screws should be inspected monthly. The Station should not be used if any of the
mounting screws are loose.
Monitor Weight
Station will be damaged if a monitor system (including the side computer mount) exceeds
the rated weight of the monitor mount. Stations can be purchased to accept 5-20 or 20-40
lb. monitor systems.
Overall
Clean only with damp cloth. No flammable cleaners or solvents that may damage the
surfaces
Overall
Do not allow children to operate or occupy Station
Overall
Only one person in the Station at a time
Overall
Do not sit on any part of the Station other than the seat bottom
Power Loss
If user is not physically able to move from the Station when reclined if power is lost, power
the Station from an uninterruptable power source (UPS)
Power Strip
The total current draw of items plugged into the power strip (other than the Altwork
electronics themselves) should not exceed 11 amps. The power strip itself should be
plugged into a properly grounded 3 prong receptacle.
Seat Back and
Do not place leg or any body part between the seat back and the seat bottom. This area
Bottom
compresses as Station is reclined and can pinch the body.
Seat Bottom
Do not place fingers or other body parts under seat bottom
Vertical Monitor
The monitor should be restrained by the user when the vertical monitor adjustment lever is
Mount
compressed. Heavy monitors will fall, light monitors may spring upward.
Contact Us:
You can contact us at [email protected] or check the online FAQ's page here: www.altwork.com/faqs
Relevant Quick Start Guide page reference
Page 3: Left View/ Cable Cover Vertical and Horizontal Arms
Page 7: Monitor Adjustments / Distance from User
confirm with [email protected]
Page 4: Power Up
Page 9: Set Up and Adjust / Adjust Seat Back
Page 7: Monitor Adjustments / Height
10