artograph MC 250 Podręcznik użytkownika - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Projektor artograph MC 250. artograph MC 250 6 stron. Professional

Drukuj stronę

Thank You...

for purchasing an Artograph MC 250 projector. This projector has been designed with superb optics

and projection characteristics, producing outstanding image quality and accuracy. The MC 250 will

enlarge any image from photos to complex designs in full color and with inﬁ nite detail. Use it to view

or trace photos and designs onto a wall, canvas or any vertical surface with outstanding results.

As with any precision equipment, treat it with care and it will provide you with years of excellent

performance. Should you need additional information or help with your projector, please contact

your local dealer or Artograph, Inc.

Upon removing the MC 250 from its packaging, check it over carefully for any hidden

damage. IF DAMAGE IS FOUND, do not proceed until damage is reported to and

inspected by the freight carrier or your place of purchase.

1. Mount projector onto a ﬂ at surface. Plug in power cord into a 110v receptacle and

turn on switch. (Fig. 1)

2. Lay copy face down onto glass copy area. Close cover. (Fig. 2)

3. Adjust distance to projection area to achieve desired image size and rotate lens to

focus. (Fig. 8)

Please read this entire operation manual

before operating the unit. Refer to the

corresponding pictures to the instructions

below.

Projection Room

For best results the projector should be

used in a room where the lights can be

turned completely off and no window light

is present. The projector works similar to

a ﬂ ashlight, so the darker the room, the

brighter and clearer the image will become.

To achieve maximum enlargement of 15

times, a minimum distance of 15 feet

is required. A 110v electrical receptacle

should be near by.

SAVE THESE INSTRUCTIONS

UNPACKING

QUICK SETUP

DETAILED OPERATION

Mounting Surface/Projection

Area

To minimize distortion of the projected

image, the MC 250 must be mounted

upon a hard, ﬂ at level surface so that the

projector is pointed perpendicular to the

projection area. The height of the surface

will depend upon the image size and where

the image needs to be projected. The MC

250 is equipped with adjustable front legs.

These should only be used when viewing

an image and not tracing, unless distortion

is desired. When the front legs are

extended and the projector is tilted up, the

image will become distorted (keystoned).