artograph Flare450 Skrócona instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Akcesoria do projektorów artograph Flare450. artograph Flare450 8 stron.

1. Powering on the device:

Turn the device "ON" using the switch on the

left side of the projector. Set the device up so

that the lens is facing a wall.

After a few seconds, the "Artograph Flare 450" logo should begin projecting. This means

the projector is starting correctly.

If the logo does not appear, the projector battery is likely not charged. To charge the

device, simply plug the charging cable into the "DC" port in the back of the projector. You

can use the projector while it is charging.

A green light indicates the projector is fully charged, a red light indicates it is charging.