Alula RE601 Skrócona instrukcja obsługi

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Akcesoria Alula RE601. Alula RE601 4 stron. Door window sensor
Również dla Alula RE601: Instrukcja instalacji (4 strony)

Drukuj stronę

Resolution Compatibles

Door Window Sensor

with industry-leading wireless range and battery life. It is

typically used to sense opening and closing of doors and

windows, but can secure just about anything using its two

external contact zones. It will alarm when the magnet is

pulled away from the sensor or when an external contact

is opened.

Features

• Industry-leading wireless range and battery life

• One door window zone and two external contact zones

• Secure encrypted wireless transmissions

• 5 year warranty

Enroll

by placing the panel into wireless enrollment mode and

then sending an enrollment signal from the sensor.

Enrollment Signal for Reed Switch

• Remove the battery tab and trip tamper to enroll

reed switch and External 1

Enrollment Signal for External Contact

• External 2 is enrolled by holding down tamper

while installing battery

Install

by mounting the sensor and magnet on a door or

window using the mounting screw locations. Make sure

to align the alignment marks on the sensor and magnet

when mounting. Additionally, the sensor can be used with

up to two external contacts.

External Contacts

• Use normally-closed contacts because the door

window sensor will transmit an alarm when it sees

an external contact open

• Do not use end-of-line resistors

• Wire contact wires to one or both outside

terminals, using the center terminal as common

• External 1 takes the place of the reed switch if

installed

• External 2 is a different zone with a different ID

• To enroll, hold down tamper while inserting

battery

Use the panel installation guide to verify proper system setup.

Door Window Sensor

RE101, RE201, RE201T, RE301, RE601

is a full-featured security transmitter

Mounting Screw Holes