Alula RE618 Skrócona instrukcja obsługi

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Akcesoria Alula RE618. Alula RE618 2 stron. Flood & temp sensor connect+ encrypted

Drukuj stronę

RE618 Flood & Temp Sensor

sensor that detects flood conditions and reports extreme

temperatures. It also reports air temperature allowing custom

high and low temperature trip points to be set in the panel.

Features

• Titanium probes for unmatched corrosion immunity

• IP67 rated waterproof enclosure

• GORE

vent to prevent seal failure

• 5-year warranty

Enroll

by placing the panel into wireless enrollment mode

and then sending an enrollment signal from the sensor.

Alternatively, the sensor can be enrolled by scanning its bar

code using the Connect+ Installer App or by entering its

8-character serial number on the interactive service provider's

web portal. NOTE, freeze and heat inputs must be enabled

as additional zones using the installer app or the interactive

service provider's web portal.

Options for Sending an Enrollment Signal

• Remove the battery tabs, OR

• Remove the wall clip from sensor body

Install

by placing the sensor in the location requiring flood or

temperature detection. If desired, the wall clip can be used to

secure the sensor to a wall or baseboard.

Optional Screw Mounting

• Remove the wall clip from the sensor body.

• Secure the clip to a wall, baseboard or cupboard

using a #6 screw.

• Slide the sensor body down onto the wall clip

until it snaps into place.

Detects

water pooled under the sensor and reports extreme

temperature conditions. High and low temperature trip points

are set in the panel.

Default Temperature Trip Points

• Heat alarms when over 100°F (38°C)

• Heat restores when under 97°F (36°C)

• Freeze alarms when under 45°F (7°C)

• Freeze restores when over 48°F (9°C)

To replace the batteries,

the front slot and twist. Slide both old batteries out and the

new batteries in. To reinstall the cover, align the rear latches

and roll the cover forward until it snaps into place.

Use the panel installation guide to verify proper system setup.

RE618 Flood & Temp Sensor

Connect+

is an integrated environmental

insert a flat blade screwdriver into

Encrypted

™

Mounting Screw Hole

Front slot

Wall Clip