Alumax ProLine PL60 Instrukcja instalacji - Strona 7

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Obudowa Alumax ProLine PL60. Alumax ProLine PL60 9 stron. Heavy frameless bypass bath enclosure

Drukuj stronę

Door Panel – Notice that the Glass Insert [P] that is used when

mounting the Rollers [Q] to the Door Glass [R] has an offset cen-

ter hole. Mount the top Rollers to the glass with the offset holes in the

Glass Insert to the left or right of the mounting holes. That will allow

a slight up or down adjustment later. Make sure that there is a Plastic

Washer [S] on either side of the Door Glass. Tighten the Rollers down

with the Roller Screw [T] through the Roller Backing Plate [U]. To hold

the threaded part of the roller while tightening, use a 3/32" Allen wrench

or other thin rod through the hole on the edge of the backing plate.

Install your handle option at this time. Place the Door Glass inside the

shower enclosure with the Rollers facing out and the handle so that it is

on the side of the enclosure that the door will strike against. CAUTION:

Make sure that you set the Door Glass on something so that the glass

and/or the floor of the enclosure is not damaged. Cardboard packing

material works fine.

Load the Bar – Place the Fixed Panel [F] on a flat surface with the

mounting holes hanging off the edge, and the inside of the panel

facing down. Place the Header Bar on the Fixed Panel with the holes

facing up. Using a thin rod, or straightened wire coat hanger, push the

Glass Mount Threaded Rods [V] into the end of the Header Bar and line

one up with each hole in the bar. Put a Glass Mount Plastic Washer [W]

on the Outer Glass Mount [X] and put the 1/4" x 1 1/2" Flat Head Screw

[Y] through them both and set the sub-assembly aside. Repeat for the

other hole. Carefully, move the Bar below the glass panel and Line the

middle hole of the bar up with the hole located 1 1/2" from the edge of

the Fixed Panel. Put an Inner Glass Mount [Z] and a Plastic Washer over

the center hole on the Header Bar and line it up with the hole closest to

the edge of the glass panel. Place the Glass Insert [AA] into the hole

and take one of the Outer Glass Mount sub assemblies and thread the

screw into the Threaded Rod inside the Header Bar (DO NOT TIGHT-

EN). Do the same for the other Glass Mount. Place a Stopper [BB] on

both ends of the Header Bar with the rubber o-ring on what will be the

top of the shower, and slide it toward the middle and snug the Set Screw

[CC] (DO NOT TIGHTEN). Slide a Wall Mount Sleeve [E] on both ends

of the Header Bar with the flat facing the end of the bar, and snug one

Set Screw [DD] (DO NOT TIGHTEN).

Page 7 of 9