Alumax Stickstall 794 Series Instrukcja instalacji - Strona 8

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Kabiny prysznicowe Alumax Stickstall 794 Series. Alumax Stickstall 794 Series 11 stron. Shower enclosure

Drukuj stronę

- 790 DOORS ONLY

Insert the two #10-24 x 7/16" square head

set screws [X] into the threaded holes in the pivot

blocks in the top and bottom rails of the glazed

door panel [M]. Position the pivot pins 1 1/2" from

the pivot side of the door (the side opposite the

magnetic strip). Tighten the set screws just enough

to prevent the pivot blocks from moving (finger

tight plus a quarter turn).

supplied by A

) will fit the set screw heads.

LUMAX

Press the white nylon spacer [Y] over the bottom

pivot pin on the door panel.

- 790 DOORS ONLY

Insert the two nylon pivot bushings [AA] into

the pivot holes in the head and curb fillers [R].

Lift the door panel [M] and insert the top pivot pin

into the pivot bushing in the header filler. Hold the

door vertical and insert the bottom pivot pin into the

pivot bushing in the curb filler. It may be necessary

to remove the header retaining screws and raise the

header slightly to install the door.

When the door has been set into place, snap the

security washer [BB] over the top pivot pin to hold

the upper pivot bushing in place and prevent

accidental dislodging of the door.

- 790 DOORS ONLY

Cut the drip rail [S] to the length of the bottom

rail minus 11/16".

Clean the bottom door rail and the

drip rail thoroughly to ensure proper adhesion. Unroll

the double stick tape [W] and carefully apply it to the

back of the drip rail (do not peel the tape backing yet).

Insert the tapered drip vinyl [U] into the drip rail.

Position the drip rail flush with the bottom and pivot

side of the door panel [M], then raise the strike side

until the bottom edge of the drip vinyl is parallel to the

curb [A]. Mark the location of each end of the drip rail.

EPH-N00-06003

5-20-97

A 3/16" wrench (not

Page 8 of 11