Artopex downtown Instrukcja instalacji - Strona 13

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Wyposażenie wnętrz Artopex downtown. Artopex downtown 13 stron.

Drukuj stronę

downtown

MOBILE PANELS

Panel with the Downtown Connection system

Step 1 :

Remove the laminate panel on the front of the lower section,

and install the electrical modules :

- Open the cover of the lower section of the panel and unscrew

the handle inside the box.

- Lift the panel and remove it.

Removable laminate panel

Step 2 :

Install the electrical outlets.

Refer to the following section for Downtown Connection system.

Place the electric outlet in this hole and plug it into

the power bar.

Plate for the Downtown Connection installation.

See the following section.

Screw the power bar onto this support using the

pre-drilled holes. Exit the cable through the bottom

access.

Step 3 :

Install the monitor.

Remove the back panel of the upper section :

- Remove the metal top cap on top of the mobile panel.

- Lift-up the panel and remove it.

- Connect the monitor. Place the cable in the cable conduit and

plug it into the power bar.

Front of mobile panel

Install the monior

Handle

Metal plate

Back of mobile panel

Remove the metal top cap

Installation guide

Installation of Downtown C. in the mobile panel

The Downtown Connection

must be installed in the lower section of

the mobile panel.

Electrical outlet

Transformer

Electronic box

Power bar

Step 1 :

Ensure that all connections are completed (p.8).

Screw the electronic box onto the metal plate with cables running

toward the cable separator (4 screws to install).

Step 2 :

Place the 4 HDMI data sharing cables in the cable access module

and keep them in place using the black plastic rings included.

NOTE, place the cables as seen below for the best use of the

system : 2 cables in front and two cables in back of the cable

separator.

Wires at front of the separator

Step 3 :

Connect the electronic box.

- Monitor cable (output)

Place the monitor cable into the cable conduit positioned

between the two sections of the mobile panel. Plug the cable

into the monitor.

- Electric cable (orange)

Place the transformer in the bottom of the metal case and plug

it into the power bar.

Cable access module

Cable separator (welded)