CUTRA Wondercutter Instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Przecinak CUTRA Wondercutter. CUTRA Wondercutter 10 stron.
Drukuj stronę
The handle gets hot.
The ultrasonic wave
vibrations
stopped.
12 About us
What materials do you want to cut?
PLASTIC
PVC FOAM BOARD
contaminated or has its shape
changed?
Is there any foreign substance
on the blade or at the end of
the vibrator?
Is a supplied blade being
used?
Was the product used for a
long time?
Is too much pressure being
held on the blade?
Is the blade and setscrew
correctly fixed?
Is the blade, setscrew, or the
end of
the vibrator contaminated?
Is there too much pressure
held on the switch button?
Does the LED light turn on
following the buzzer sound?
Clean the inner parts of
blade, collet, setscrew, and
the end of the vibrator.
After 10 minutes of use the
product automatically turns
to Stand-by Mode. Press
the handle switch to use
the product again after
cooldown for safe use.
The device may get hot
sooner and turns to
stand-by state after using
less than 10 minutes if
you try cutting hard or
thick materials.
The product is a light
ultrasonic wave cutter. Do not
exert too much power and hold
it correctly.
If the blade is not correctly
fixed, the vibration
temperature can affect
negatively on the
product ' s life cycle.
Clean the inner parts of
blade, collet, setscrew, and
the end of the vibrator.
The blade is stuck.
Relax before using it again.
It ' s a stationary state due to the
high temperature. Wait until the
handle temperature cools
down.
To prevent the product from
overheating, it automatically
stops operating and turns into
the stand-by state. Turn the
power button off and check
the setscrew before restarting.