DKW RT 250 Instrukcja serwisowa - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja serwisowa dla Motocykl DKW RT 250. DKW RT 250 17 stron.

Drukuj stronę

New bring eqine with support in a vertical

position as shown in the i11.4, tighten

handle sewrely in joint piece. Unscmw generator cover, extrad the ngulator with WI,

mmove the clutch thrust md and mbber seal and also the switch for the neutriil position

indicator.

See illustration

table 5

t 8

Loosen connections 1,30 and Dt on rcpulator and genentor switch spanner No. OlOU268-0

and pull out wiring in ths dinction

of the clutch side. Take out the rubber gmmtrtit.

Unscrew the two bolts'holding the generator and remove field winding together with PB-

gulator and contad breaker basc plate.

Extact the armzturs rith otPPtuie'Oxtrsldfqvbollt;anl

ndvtlha).

Insert chain

Sprocket holder No. Ol@246-0, loosen leck plate and qt. Attention ! Left hand

thrsad ! Reek%e flaqe with Paper gasket, washer and oil conductiq disc, Extrakt

chain spmcket and cover plate with Paper gasket, oil seal and rate.

Reaove the foot Change and kickstarter

trank with aid of

SCF)W driver, haviq

praviously locsened the clampiq bolts. Unscrsw five cover bolts ( Attention :

Washsrs !) Renove cover and gasket, check chain slack ( slack: Total width up and

down). If slack exceeds 15 me (19/32 inch) replace chain. Remove washer fmm kickstarter

shaft. If chain is to be ra-used, mark same on the outside.

See illustration

table 8

Pu11 out the five clutch spriqs with puller No. OllN161, turn by 90' to the left and

then let ths spriqs snap back. Remove clutch components. Note Position of'lined-

and

steel plates ! Insert clampiq piece No. OlUO244-0 and remove chain Sprocket nut

( right hand .thrsad).

See illustration

table 9

Remve extractiq

holt, insert clutch counter support No. U'ioO2536 and clamping piece

Ol00244-0 and also loosen

cl~tch

tage rm~t. ( Left iad thraad !) Remove drive brackst.

Sse illustration

table 10

Scrvw the chain sprockzt extractor G100248-0 to spmcket ad extrad

fron trank-shaft.

The entire drive unit incl. chain and kickstarter assembly tan mw be ramoved. Note

Position, wantity and thickness of washers behind the clutch drum. These arv im-

portant for adjustiq

chain aligtneent.

See ill*tration

Zahle 11

Nee the four nuts securiq ths cylinderhead should be unscmwed. A suitable spanner

No. 4701~ao3-00 is supplisd with the rotorcycle tools. Remove cylirxterhead, gasket,