Cutters Edge CE807R-B1 Series Instrukcja obsługi - Strona 18

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Piła Cutters Edge CE807R-B1 Series. Cutters Edge CE807R-B1 Series 19 stron. Rotary rescue saw

Drukuj stronę

General Maintenance Instructions

Below you will find some general maintenance instructions. These are general guidelines. Maintenance of the saw is encouraged
after each use. If you have more questions, contact your local authorized service center.

DAILY MAINTENANCE

1
Check that the components of the throttle control work smoothly (throttle control and throttle trigger lock)
2
Check the tension and condition of the drive belt.
3
Check the condition of the blade and the drive gear.
4
Check the condition of the blade guard.
5
Check the starter and clean the outside of the starter unit's air intake.
6
Check the starter cord and D handle for wear or damage.
7
Check that all nuts and screws are tight.
8
Check that the stop switch functions correctly.

WEEKLY MAINTENANCE

9
Check, clean or replace the main foam filter.
10
Check that the handles and vibration damping elements are not damaged.
11
Clean the spark plug. Check that the electrode gap is 0.020 inch (0.5 mm)
12
Clean the fins on the flywheels. Check the starter and the recoil spring.
13
Clean the cooling fins on the cylinder.
14
Check that the muffler is securely attached and not damaged.
15
Check that the spark arrestor is free from debris build-up.
16
Check the operation of the carburetor.

MONTHLY MAINTENANCE

17
Check the K&N gauze filter.
18
Check the clutch center, drive gear, and clutch spring for wear.
19
Clean the outside of the carburetor.
20
Check fuel hose for cracks or other damage, change if necessary.
21
Clean the inside of the fuel tank.
22
Check all wires and connections.

DETAILED SAW CLEANING

1. Wipe down the saw after every use.
2. Clean out any build up inside of the blade guard by removing the blade guard. (Refer to blade removal section).
3. To thoroughly clean the inside of the saw you will need to:
(NOTE: As the saw is being disassembled, check for broken or worn parts)
a) Remove the front cover, air filter cover, and air filters. (Refer to air filter removal section).
b) Remove the three 4mm Allen screws that hold the cylinder cover in place. Remove the cylinder cover, taking care not to
lose the O-Ring located under the cover.
c) Remove the retaining nut that holds the stop switch in place and push the stop switch back into the case.
d) Remove the cylinder cover, making sure you work the stop switch out of the cove before completely removing the
cylinder cover.
e) Remove the starter by loosening the 4 screws that hold the starter cover in place.0
f) Remove the plastic air deflector, use care when handling the wires that are attached to it. (Check wires for damage or wear)
g)Remove the cutter arm. (Refer to Removing and Inspecting the belt section)
4. Clean the powerhead and cooling fins with solvent. A putty knife or similar tool may be used to remove stubborn debris.
NOTE: Do not allow solvent to enter the carburetor or muffler when cleaning.
5. Compressed air may be used to dry the saw or you may allow it to air dry naturally.
6. Once the saw is dry, it can be reassembled in reverse order.
7. Test-run the saw after reassembly.
17