Cutting SQ30-2B Podręcznik - Strona 10

Przeglądaj online lub pobierz pdf Podręcznik dla Przecinak Cutting SQ30-2B. Cutting SQ30-2B 15 stron. Portable electric pipe threader

Pre-Operation Inspection

Before each use, inspect power drive and correct any problems to reduce the risk of serious

injury from electric shock, crushing injuries and other causes and prevent power drive damage.

1. Make sure that the power drive is unplugged.

2. Inspect the power cord and plug for damage. If the plug has been modified or if the cord is damaged,

do not use the Threader until the cord has been replaced.

3. Inspect the Threader for any broken, missing, misaligned or binding parts as well as any other

conditions which may affect the safe and normal operation of the tool. If any of these conditions are

present, do not use the Threader until any problem has been repaired.

4. Use tools and accessories that are designed for your Threader and meet the needs of your application.

The correct tools and accessories allow you to do the job successfully and safely. Accessories suitable for

use with other equipment may be hazardous when used with this Threader.

5. Clean any oil, grease or dirt from all equipment handles and controls. This reduces the risk of injury due

to a tool or control slipping from your grip.

6. Inspect the cutting edges of your dies. If necessary, have them replaced prior to using the Threader.

Dull or damaged dies can lead to binding and poor quality threads.

7. Check the level and quality of the thread cutting oil. Replace or add oil if necessary.

NOTE! Thread cutting oil lubricates and cools the threads during the threading operation. A dirty

or poor grade cutting oil can result in poor thread quality.

Operating Instructions

Adapter is required for 1/2" through 11/4" 11-R Die Heads. Push Adapter into threader and tighten the ring

at opposite side (Figure 1 & 2). Installation can be made from only one side of the threader.

Fig 1

Fig 2