ALUZ A1-ZYZY-SQR Instrukcja instalacji - Strona 8
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt oświetleniowy ALUZ A1-ZYZY-SQR. ALUZ A1-ZYZY-SQR 11 stron.
Drukuj stronęZYZY
Square
A1-ZYZY-SQR
1
Measure area where luminaire will be installed. Use a laser line to ensure a
straight installation.
Example: 22'4" Run (8' + 8' + 6'4").
Note: To retain Wet Location, luminaire may not be mounted with the lens
facing upwards.
2
Determine number of Mounting Plates needed for each run.
Refer to Mounting Guidelines to ensure correct number of Mounting Plates.
3
Mark location where Mounting Plates will be installed along laser line.
Note: Mounting holes on Mounting Plates must be aligned with direction of
luminaire.
Laser Line
4
Lay Mounting Plates and pre-drill using proper drill bit for surface and screw
size. Each mounting plate must be secured to a solid surface such as a wall
stud or secured to drywall using drywall anchors. Only install Mounting
Plates on flat, even surfaces.
Note: Use #8 flat head countersink screw.
5
Screw Mounting Plates to surface.
6
Determine location where conduit power feed will be fed through the
mounting surface. Drill a hole in mounting surface in line with the Mounting
Plates, then pull conduit through.
Note: Size of hole to be determined by installer.
7
Remove Bottom Cap from luminaire and drill a hole where power will be fed
to luminaire.
Note: Refer to Feed Point Assembly for details.
Remove Bottom Cap
Input Wiring to Driver
Mounting Plate
Laser Line aligned with mounting holes
Hole for Mounting Plate
Hole for Conduit
(Made by installer)
ALUZ
1170 North Red Gum Street, Anaheim, CA 92806
Phone: 800 921 2254 or 714 535 7900 | Fax: 714 535 7902 | [email protected] | aluz.lighting
© ALUZ All rights reserved. ALUZ reserves the right to make changes or withdraw specifi cations without prior notice.
8
Making wiring connections from conduit to driver using splice connectors.
Use Hardwire Connector or cut off yellow disconnects if applicable. Stagger
the splice connectors to save space inside the extrusion. Use a weatherproof
Conduit Fitting (by others) to secure conduit to Bottom Cap.
Note: Refer to Wiring Diagrams before connecting wires.
Splice Connector
(By Others)
9
Replace Bottom Cap onto luminaire.
Snap Bottom Cap onto extrusion
Installation Instructions
9 / 1 / 2021 / Rev 0
Wet Location Mounting (1 of 2)
Flex Conduit
(By Others)
Conduit Fitting
(By Others)
Assembled Conduit Fitting
Page 8 of 11