DLS DD31T Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz DLS DD31T. DLS DD31T 20 stron. Dd series 600w /3 channel class d full digital amplifer

Drukuj stronę

1. SUBWOOFER INPUT Connector

This is both a Low and High Level Input port. Using the supplied wiring harness for low level RCA inputs or as

instructed on Fig.9 High Level (speaker level) input.

2. SUBWOOFER GAIN Control

This control is used to match the input sensitivity of the amplifier to the particular source unit that you are using up to 250mV to 5

volts.

3. LPF (Low Pass Filter)

This control is continuously adjustable from 50Hz to 150Hz at 12dB per octave.

4. AUX Input Jack

This 1/8-inch (3.5mm) mini jack can be used to accept an MP3, iPOD or smartphone as the source unit from that devices

headphone (3.5mm) output.

NOTE: INPUT switch needs to be in the 2CH setting when using AUX Input to provide signal for both front and sub amp

section.

The AUX input is internally paralell to the ordinary front input. Turn off or disconnect the source not used to avoid

mixing.

5 . BASS EQ Control

This equalization circuit is used to enhance the low frequency response of the vehicle's interior. With up to 18dB of boost

centered at 45Hz, the BASS EQ can be adjusted to meet your own personal taste.

DD31T CONTROL PANEL LAYOUT

Fig. 2 - 3 Channel Panel Layout