DLS Effects EchoTAP Podręcznik użytkownika - Strona 2

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt muzyczny DLS Effects EchoTAP. DLS Effects EchoTAP 2 stron. Tape echo simulator & 2 channel delay

Drukuj stronę

Power "+9vdc": Input for 9 to 13.8vdc, 90ma minimum, 2.1mm jack, polarity does not matter. (DC adapter

included)

Operation:

Switching from Echo-1 echo to Tap Tempo echo:

While in Echo1 mode (Red LED on) I want to switch to Tap Tempo: Push and release the Echo1/Tap

Tempo switch. The Yellow LED will light and blink at the Tap Tempo rate. The Red LED will un-light.

Note1: You don't have to hold down the Echo1/Tap Tempo switch when switching to Tap Tempo. As soon

as the switch is pushed you immediately go into Tap Tempo mode as indicated by the Yellow LED blinking,

so just release the switch.

Recording a new Tap Echo Time:

While in Tap Tempo mode, I want to change the echo tempo: Push and release the Echo1/Tap Tempo

switch at least 2 times to the beat you desire. This will set the delay timing and the Yellow LED will now

blink to the beat you set.

Note1: On power up the Tap Tempo is pre-programmed to ¼ second echo time.

Note2: When setting the tap tempo, don't hold the Echo1/Tap switch down for more than ¾ of a second or

you will exit the Tap Tempo mode. Try to press and release while setting the echo beat.

Switching from Tempo echo back to Echo-1 echo:

While in Tap Tempo mode, I want to switch back to Echo1 mode: Push and hold the Echo1/Tap Tempo

switch for at least ¾ of a second. After the Red LED lights, release the Echo1/Tap Tempo switch. The

Yellow LED will un-light.

Note1: You have to push and HOLD the Echo1/Tap switch for at least ¾ of a second to get back to Echo1

mode.

General Notes about Tap Record Mode:

• Tap echo is preset for ¼ second (250ms) upon unit power up. The user may wish to leave this setting

at ¼ second, or change it using the "Recording a new Tap Echo Time" instructions above.

• In TAP mode, once you push and release the switch you enter the RECORD MODE where you can set

the tap tempo. You can push and release the switch again to set the new tap rate, but only up to 3

seconds from the 1

will exit RECORD MODE. To re-enter record mode, simply push the switch again.

• I pushed the Echo1/Tap Tempo switch by accident while in Tap mode and I did NOT want to record a

new Tap Echo time. If you didn't want to change the echo time, just don't push it again for 3 seconds

and you will keep the current echo time. This is because if the system doesn't see a second switch

push in 3 seconds, it exits RECORD MODE.

Electronics:

Technology: Hi Quality Analog (HQA) electronics and 16bit digital electronics

Sample rate: 44.1KHZ, 256x over sample

Mechanical:

Enclosure: Solid heavy gauge steel, 5"W x 4.9"D x 2.4"H

Powder coat painted for durability!

Controls: Steel switches, pots, and ¼" jacks

Weight:

2½ lbs.

DLS

Effects, Inc

switch push. However, if you do not push the switch again within 3 seconds you