AIO ROBOTICS ZEUS Skrócona instrukcja obsługi - Strona 2

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Drukarki 3D AIO ROBOTICS ZEUS. AIO ROBOTICS ZEUS 2 stron. 3d scanner, 3d printer
Również dla AIO ROBOTICS ZEUS: Skrócona instrukcja obsługi (2 strony)

Drukuj stronę

WHAT'S INSIDE

A. ZEUS machine

B. White filament (stored into the ZEUS)

C. Accessory box containing turn table,

glue stick, wifi dongle and calibration

pattern.

D. Accessory box containing power supply

UNPACKING ZEUS

1.1

Open main box top flaps. Lift out box D, top

Reach down inside protective bag, lift

layer of foam, then box C from front side.

ZEUS from base and up out of the box.

1.4

Lift open ZEUS front door with the handle.

Carefully remove inside filament box B.

1.7

Remove powercable from box D.

Remove glue stick + wifi dongle from box C.

POWERING ZEUS

2.1

Turn ZEUS to back. Insert power cable flat side

Turn ZEUS to front. Press and hold button

up into round outlet and push right switch to 1d.

for 1 second. It will blink then remain green.

LOADING THE ACCESSORIES

3.1

Take the unwrapped glass turntable, with the

Gently rotate the plate with your finger

3 pins facing DOWN and gently place inside.

until you hear it drop into place.

1.2

Place the ZEUS machine on a stable

surface.

1.5

Carefully remove the inside protective foam.

1.8

Remove turntable from box C.

2.2

With front touch screen lit up,

your ZEUS is now powered up.

3.2

Insert the wi-fi dongle from box C

into one of the front USB ports.

LOADING THE FILAMENT

Unwrap filament box B. Open ZEUS side door.

4.4

1.3

Slide off the small black spools from left side of ZEUS. With the pie shapes facing in, click into place on each side of filament spool

1.6

With the bar code facing you, gently rotate the filament spool clockwise to tighten any slack. Place onto side metal stick. Close side door.

1.9

The filament is now ready to load into the extruder. Press control button

Take the end of the threaded filament & feed all the way down into the top center hole of the extruder. With other hand use your thumb &

2.3

index finger to squeeze right side extruder tabs together. This allows you to feed filament all the way down into the extuder head.

PRINTING

For your first print, you'll need to prep the plate with glue stick. Cover the estimated base surface area of your printout Press print button.

Choose your file. Either a gcode or .STL. Press gcode to select a preloaded file. You can preview the file. Zoom in and rotate to view.

3.3

When happy with your choice, select PRINT. ZEUS will start the print after correct temperature is reached, outer probing, height and

position of plate is measured and after nozzle has self cleaned on the rubber pad. After the printing has stopped lift out plate and

remove printout.Please note that print times vary. It can take just a few minutes or several hours depending on the size and density of

the object.

4.1

4.2

Find white guide tube top right then push

the filament into the tube until it enters other

4.5

4.7

4.8

4.10

4.11

once, then the press park button to bring extruder head forward.

4.13

4.14

5.1

5.2

5.4

5.5

4.3

With one hand over the top in the main area,

gently pull it through another few inches

4.6

4.9

4.12

4.15

5.3

5.6