10-8 Video ARSENAL Instrukcja instalacji - Strona 9

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla DVR 10-8 Video ARSENAL. 10-8 Video ARSENAL 10 stron.

1. 8: Connect the power cord

Connect the power cord to the 6PIN power input interface on the rear panel of the DVR, while the red and

black cables are directly connected to the battery of the vehicle, i.e. positive terminal and negative terminal

respectively. The yellow cable is connected to ACC, a switched 12v power source. The unit will boot up and

shut down automatically when the vehicle is running and turned off.

When the DVR is not installed in a vehicle or under test, you can use a switching power supply above

DC12V-5A to supply the power.. In this case, twist the red and yellow cables together to connect it to the

positive terminal, while the black one is connected to the negative terminal separately.

This terminal is connected to the power interface on the rear panel of the MDVR

Before connecting, check that the voltage ranges from 8V to 36V. If not, the device will not power on.

It is recommended that the DVR be directly powered from positive and

negative terminals of the battery or fuse panel The power cable used for

positive and negative terminals should have a size of 14 AWG or above.

1. 9: Connect the display output unit

The Yellow 4-pin adapter on the White Sensor Harness is video output. Attach this to the long monitor

cable that gets routed through the vehicle to connect the either (default) mirror monitor or 7 inch standalone

monitor.

10-8 Video

Install Instruction for ARSENAL DVR

888-788-1048