AKO AKOGAS AKO-576410 Instrukcje

Przeglądaj online lub pobierz pdf Instrukcje dla Detektory gazu AKO AKOGAS AKO-576410. AKO AKOGAS AKO-576410 2 stron.

Drukuj stronę

5764H002 Ed.01

Instructions

AKO-576410

AKO-576032

Installation

Opción B

Fixed by screws

3 6

Technical specifications

Power supply ...............................................................................................................................................................12-30 Vdc

Consumption........................................................................................................................... Typical: 75 mA, Maximum:150 mA

Alarm relay .........................................................................................................................................SPDT 30 Vdc, 2A, cos j =1

Working ambient temperature....................................................................................................................................-20 to 50 ºC

Storage ambient temperature.....................................................................................................................................-20 to 60 ºC

Range of moisture permitted...................................................................................................0 - 95 % RH (Without condensation)

Protection degree With cable entry using cable gland .............................................................................................................IP68

With cable entry from the back ...................................................................................................................IP40

Dimensions ..........................................................................................................................107 mm (W) x 85 mm (H) x 39 mm (D)

Complies with the EN 14624 standard.

General warnings

-Using the unit without observing the manufacturer's instructions may alter the appliance's safety requirements.

- Detectors should be installed in a place protected from vibrations, water and corrosive gases, where the ambient

temperature does not exceed the value indicated in the technical data.

- Detectors supervise a point and not an area. If the gas leak does not reach the sensor, or the level of

concentration in that point does not reach the alarm values, no alarm will be activated. If perimeter

supervision is required, several sensors should be installed around that area.

Working conditions:

-Keep the detector work environment free of chemical agents (such as solvent, paints, alcohol, acetone, silicone, etc.), and

free of engine fumes or gases from fermentations (bread, pizza) or ripening (breathing) of fruits.

-The detector should generally be installed in an area of potential concentration/accumulation of gas, in low positions (due

to the greater relative density, in relation to air, of the gases subject to detection).

-The AKO-576410 / 576032 refrigerant gas detector may only be used in locations that have not been classified with risk

of explosion.

-Reference regulations: EN 378

-Applicable local regulations: Compliance must be ensured

Carefully perforate the rear entry so as not to damage

the electronic board.

This option involves changing from IP68 to IP40.

m m

7 0

m m

With cable entry using cable gland

If the cable entry at the

back has not been drilled,

this option provides the

IP68 rating.

Ø 2,8 mm

Ø 5 mm

Option A

Fixied by an

adhesive

Connect following the

diagrams