DNP DS80 Skrócona instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Drukarka DNP DS80. DNP DS80 6 stron. Photo imaging
Również dla DNP DS80: Skrócona instrukcja obsługi (8 strony), Instrukcja przepakowywania (2 strony)

Drukuj stronę

DS80DX Printers Troubleshooting

LED Displays

Use the blinking LEDs in conjunction with the

system messages to pinpoint problems with the

printer, such as paper jams, ribbon errors, open

printer doors, etc.. If a problem persists, call

Technical Support.

DNP Imagingcomm America Corporation

DS-Series™ Printer Quick Reference

Fixing Simplex Paper Jams

1. Open the printer.

2. Remove the ribbon cassette by pulling it up

and out.

3. Pull any paper remaining in the direction

indicated and cut off the excess evenly with

scissors.

4. Remove the scrap box and rewind the paper.

Cut off any partially printed, wrinkled or

otherwise inferior paper evenly with scissors.

NOTE:

Make sure you cut the paper as evenly as

possible. Failure to do so

can result in another paper

jam.

5. Advance the paper so that the paper is

feeding into the printer from the bottom of

the paper compartment. The printer beeps

when the paper is in the

correct position.

6. Replace the scrap bin,

and close the top of the

paper compartment.

7. Close the paper and

media compartment drawer.

8. The printer will cycle through the lights as

it adjusts the media. When the media is

aligned, four blank test images are printed.

Fixing a Ribbon Tear

1. Open the media compartment drawer.

2. Remove the ribbon

cassette.

3. Cut the ribbon. Carefully

remove any remaining

ribbon from inside the

mechanism.

4. Reattach the ribbon

using cellophane tape, as

shown.

5. Advance the ribbon several

times towards the take-up

spool until the tape is no

longer showing.

6. Make sure there is no slack

in the ribbon. Replace the

cassette in the printer.

ATTENTION:

Make sure the ribbon is placed in correctly.

The media compartment drawer will not close if

placed improperly.

7. Close the media compartment drawer. The

printer will re-initialize.

ATTENTION (DS80DX ONLY):

Due to two different paper supplies (rolled

simplex and sheeted duplex paper) the printer

ribbon will run out before the paper. For ONLY

DS80DX printers, it is advised to change the

ribbon and paper as necessary, and not at the

same time.

Release: v01.2017

PN: 35-260-2-SA