Doberman SE-0114 Podręcznik
Przeglądaj online lub pobierz pdf Podręcznik dla System bezpieczeństwa Doberman SE-0114. Doberman SE-0114 4 stron. Pool alert
Drukuj stronę
PACKAGE INCLUDES:
Pool Alert...1PC
Accurate Entry Sensor...1 Set
INSTALLATION:
For pool gates and standard doors: Attach the Pool Alert to the door or gate by peeling off the tape or by utilizing
the butterfly hole. Then affix the individual entry sensor pieces to the gate/door frame with the included peel and
stick tape. Place the individual entry sensor pieces adjacent to each other as shown in illustration #1.
For sliding glass doors and windows: Follow the instructions above. Although the door or window will slide
instead of opening outward, the trigger mechanism is installed the same way. See illustration #2
For doors or windows with an uneven door jamb: Only use the piece of the entry sensor trigger mechanism with
the pin. The raised door jamb is used instead of the other piece to activate the alarm. See illustration #3.
It is recommended that you install the Pool Alert 54 inches above the threshold of the door or gate.
BATTERY INSTALLATION/REPLACEMENT:
Loosen the screw and slide down the battery cover in the lower part of the back panel.
Follow the polarity instructions, and install two AAA Alkaline batteries (not included). Then gently slide the battery
cover up.
After installing the batteries, the unit's red LED light will flash continuously.
Choose a 3-digit bypass code and enter it. There will be several short beeps and the red LED light will stop
flashing to show that your code has been successfully set. The unit now is ready to work.
If you forget your code, simply re-install the batteries and follow the steps above again.
OPERATION:
Make sure the product is properly installed as directed above.
When the door, gate or window is opened, the ALARM will go off
The alarm will continue to sound until it is turned off by pressing the bypass code or until the batteries are drained.
To pass through without triggering the ALARM, enter your bypass code and a series of beeps will be heard. You
now have 15 seconds to open the door or gate without triggering the ALARM.
NOTES:
Check the alarm condition periodically to ensure that the unit has sufficient battery power to operate properly as a
pool alarm.
To test the battery condition, simply open the gate/door. The loud alarm sound indicates its batteries are in good
condition.
If the batteries become weak, the LED will flash and the unit will beep periodically (every 30 seconds). Replace
with two fresh alkaline batteries immediately.
DISCLAIMER:
All Doberman Security items are strenuously tested by our experienced R&D teams. Doberman, however, does not
guarantee that this item will prevent all theft and/or accidents from occurring. This item is only meant to act as an alarm
and alert the user of an entry opening into your pool or spa area.
LIMITED WARRANTY COVERAGE:
If your product does not work properly because of a defect in materials or workmanship, Doberman will, for the length
of the period as follows, which starts with the date of original purchase ("warranty period"), replace it with a new or a
refurbished product.
Product
All Doberman Brand Products
During the parts warranty period, there will be no charge for Parts. You must first email acquiring a RMA number, and
then mail-in your product during the warranty period. This warranty only applies to products purchased and serviced in
U.S.A./CANADA
SE-0114 POOL ALERT
Safeguard your pool or spa
CONFORMS TO ALL STANDARDS OF UL 2017
Parts
Ninety (90) Days
immediately,
Services
Mail-in
accompanied by a flashing LED.