Dobinsons BU59-3660 & BU59-3510 Instrukcja instalacji - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria samochodowe Dobinsons BU59-3660 & BU59-3510. Dobinsons BU59-3660 & BU59-3510 11 stron. Bullbar toyota hilux vigo 2005 - 2011
Drukuj stronę
Fitting Guide
1. Remove the number plate.
2. Remove the grill by removing the screws and
clips in the top and then un-clipping the lower
section from the bumper.
3. Remove the bumper by removing the 2 clips
at the top in the centre, the 4 bolts on the
support mounds that mount to the cross
member, the 6 bolts underneath, and the 2
bolts in the wheel arch.
4. Then pull away the wheel arch splash guard
and right at the very back at the top there is
another clip that can be removed on each
side. Unclip the fog light wiring loom from
each side and remove the bumper.
5. Remove the bumper support by removing the
4 nuts, and the 2 clips on each side that attach
it to the bottom splash guards.
Dobinsons Springs and Suspension
6. Remove the plastic shrouds from between the
headlights and the radiator face.
7. Remove the headlights there are 3 screws on
the top and one bolt on the side.
8. Remove the original bump support mounts by
removing the 3 screws at the back of each.
9. While the headlights are out it is now a good
time to run the wiring for the new parker
lights and indicators.
10. Wire up the lights. Using a multimeter or test
light first locate the earth wire, parker positive
and indicator positive wires from the wiring
on the back of the original vehicle lights on
each side. This is easiest done by reaching in
behind the wheel arch liner and unclipping
both lights plugs for easier access.
11. Unclip the wiring from the indicator/parker
lights. Check that the wiring will be long
www.dobinsonsprings.com