Dobinsons BU63-3675 Instrukcja instalacji - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria samochodowe Dobinsons BU63-3675. Dobinsons BU63-3675 13 stron. Bullbar for vw amarok
Drukuj stronę
Fitting Guide
1. Remove the number plate.
2. Remove all screws and bolts holding the lower
section of the bumper to the vehicle.
3. Align the template on the vehicle as seen
below NOTE: For models without flares fitted
the template will wrap around into the wheel
arch slightly.
4. Mark a line along the template edge on both
sides of the vehicles. The bottom edge will
align with the bottom edge of the bumper bar
grill recess.
5. Mask along the top side of the line marked in
step 4 to prevent scratching to the top side of
the bumper.
Dobinsons Springs and Suspension
6. On flared models it may be easier to remove
the flare sections attached to the bumper
before cutting.
7. Carefully using a pneumatic hacksaw or
equivalent cut along the marked lines in step
4, starting from the wheel arch edge first,
then along the line at the fog light recess,
then along the line at bumper bar grill recess
cutting through the grill vertical columns.
8. Carefully cut the flares if they have been
removed from the bumper, and re install to
vehicle.
9. Removed the burrs from the bumper and
flares and install the rubber pinch edging on
outside edges of the cut bumper.
www.dobinsonsprings.com