ET Solar ET-M536 series Instrukcja instalacji - Strona 4
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Panel słoneczny ET Solar ET-M536 series. ET Solar ET-M536 series 10 stron.
Drukuj stronę- 1. 1 Company Introduction
- 2. 2 Structure of Module
- 2. Table of Contents
- 2. Installation
- 3. 3 Installation of Modules
- 3. Mounting with Bolts
- 3. Mounting with Clamps
- 3. Anti-Salt Module Mounting Procedure
- 3. Grounding of Normal Modules
- 3. Fire Safety
- 3. Junction Box
- 3. Output Voltage, Current and Maximum Power
- 4. 4 Characteristics of Modules
- 5. 5 Operation and Maintenance
- 6. 6 Disclaimer of Liability
- 7. Appendix 1：Electrical Ratings of ET Solar Modules
Fig. 3 Module mounting with clamps
3.1.3 Anti-salt module mounting procedure
For photovoltaic systems to be installed near the coastline, we recommend using ET
SOLAR Anti-salt modules with the following installation action items.
Mainstream Grounding Methods:
4
www.etsolar.com
Subject to technical modifications without notice. 2016 © ET Solar Group
Grounding bolt
Fluorocarbon paint
Grounding wire
Option 2
Grounding System Installation Steps:
1) Before the installation of each module, clean the frame installation area (35mm by
100mm surrounding the grounding hole) and keep it dry.
2) Choose either one of the two options described in the diagrams above to properly
ground the module.
3) Spray varnish on the yellow portion of the diagram covering the entire grounding
area. We recommend fluorocarbon varnish.
Recommended mounting methods
For mounting system with bolts, refer to picture 1 and 2.
Hexagonal screw
Plain washer
Elastic washer
Insulation gasket
Picture1
www.etsolar.com
Subject to technical modifications without notice. 2016 © ET Solar Group
www.etsolar.com
Fluorocarbon paint
Grounding wire ring
Grounding wire
Picture 2
5