ET&F 610 Instrukcja obsługi i instrukcje bezpieczeństwa - Strona 16

Przeglądaj online lub pobierz pdf Instrukcja obsługi i instrukcje bezpieczeństwa dla Pistolet do gwoździ ET&F 610. ET&F 610 20 stron.

Drukuj stronę
Maintenance chart
ACTION
Drain air line filter daily.
Keep lubricator filled.
Clean filter element — then blow
air through filter in direction
opposite to normal flow.
Clean magazine and feeder
mechanism.
Keep push lever working properly.
Lubricate the Nailer after nailing.
Drain air compressor.
Operator troubleshooting
Most minor problems can be resolved quickly and easily using the table below.
If problems persist, contact an authorized service center for assistance.
PROBLEM
Nailer operates, but no pin is driven.
Weak drive.
Slow to cycle.
Drives too deep.
Skipping pins. Intermittent feed.
Pins jam.
Driven pin is bent.
Drives properly during normal
operation, but does not drive fully
at faster fastening speeds.
WHY
Prevent accumulation of moisture
and dirt.
Keep the Nailer lubricated.
Prevent clogging of filter with dirt.
Prevent a jam.
Promote operator safety and
efficient Nailer operation.
Extend the Nailer life.
Keep the Nailer operated properly.
CHECK METHOD
Check for a jam.
Check function of feeder per
page 14.
Check for proper pins.
Check air pressure.
———
Driver blade worn?
Piston ring worn or damaged?
Check air pressure.
Check for proper pins.
Check function of nail feeder per
page 14.
———
Check position of nail holder in
magazine per page 10.
Piston ring cut or heavily worn?
Check for proper pins.
Driver blade worn?
Check inside diameter of air hose.
— 16 —
HOW
Open manual petcock.
Fill with pneumatic tool lubricant.
Follow manufacturer's instructions.
Blow clean daily.
Blow clean daily.
Supply 2 – 3 drops of lubricant
into the Nailer.
Open petcock on air compressor tank.
CORRECTION
Clear a jam per page 14.
Clean and lubricate.
Use only recommended pins.
Increase air pressure. (Do not
exceed 120 psi (8.3 bar 8.5 kgf/cm
Use pneumatic tool lubricant.
Contact ET&F for replacement.
Reduce air pressure.
(Adjust 70 – 120 psi)
Use only recommended pins.
Clean and lubricate.
Use pneumatic tool lubricant.
Adjust nail holder to proper position.
Contact ET&F for replacement.
Use only recommended pins.
Contact ET&F for replacement.
Use larger air hose.
2
))