Dock N Stow GEN2 Obsługa i instrukcje
Przeglądaj online lub pobierz pdf Obsługa i instrukcje dla Akcesoria samochodowe Dock N Stow GEN2. Dock N Stow GEN2 2 stron.
Drukuj stronę
Read All Instructions! Failure to Follow All Instructions Listed Below May Result In An Unsafe or Dangerous
Condition.
Contents of package: 1 Dock N Stow; 4 grey spacers.
• Magnets need to be kept at a safe distance from all magnetic storage devices, electronics and credit cards etc....
• Insure that the magnet is stored in the "OFF" position when not in contact with Ferromagnetic metals (such as iron). The magnet can be left ON or
OFF indefinitely without harm. When ON and near Ferromagnetic metals (such as steel) there will be a sudden and powerful attraction.
• DO NOT attempt to disassemble or alter the Dock N Stow magnet; there are no user serviceable parts inside the device.
• All Dock N Stow products are designed for normal conditions, do not use underwater or in a hazardous environment.
• DO NOT use the magnet if it is damaged or is not working properly. Severe injury can occur if this device is not used properly and safely.
• DO NOT expose the Dock N Stow magnets to temperatures above 180 deg Fahrenheit (80 Celsius). High temperatures will permanently degrade the
magnet's effectiveness and may result in an unsafe condition.
• This product contains PTFE lubricant. For MSDS information contact Dock N Stow.
• Always keep the bottom of your Dock N Stow clean and free of debris and rust.
Dock N Stow Assembly:
Step 1
- Determine trailer frame location you will be using for your new frame mounted Dock N Stow stabilizer block. This location will need 7 inches of space.
Step 2
- Measure the top width of the trailer frame; This measurement is used to determine how many spacers are needed for your frame size.
3-inch trailer frame requires no spacers.
•
2.5 inch trailer frame requires two spacers. One spacer will be used on either side of the channel at the bottom of the block.
•
Slide spacers into dovetail grooves until they snap into the bottom of the block.
•
2 inch trailer frame requires four spacers. Two spacers will be used on either side of the channel at the bottom of the block.
Slide spacers into dovetail grooves until they snap into the bottom of the block.
Step 3
- Remove top insert if necessary for use with caster wheel.
•
If a wheel is on the bottom of your jack post, remove top insert for wheel dock using Phillips head screwdriver.
Thank you for purchasing a Dock N Stow product!
GEN2 Operation and Instruction