DockCraft 100 Series Podręcznik - Strona 7

Przeglądaj online lub pobierz pdf Podręcznik dla Sprzęt żeglarski DockCraft 100 Series. DockCraft 100 Series 15 stron.

Installation Procedure for Your - Series 100 Docksider
Series 100 – Bolt On Dock Mount Installation
1 - Select a position on your dock where you choose to mount your Kayak Storage Rack.
Ensure there are not any electrical or structural components in the area.
2 - The Docksider should be mounted on 1 section of your dock.
3 - Make sure the wood on your dock is solid (not cracked or rotting) at the installation
position.
4 - Ensure there are no obstructions above or below your dock.
5 - Place one Dock Mount on your Dock and position as shown below
6 - Install
Dock Surface Mount
Your Dock
At the install position align Dock Mount as shown above
With a pencil scribe the hole locations (2) on dock surface
While the dock mount is positioned as shown above
Install the TOGGLER® brand SNAPTOGGLE® anchor *
Hold metal channel
flat alongside plastic
straps and slide
channel through hole.
Minimum clearance
behind wall: 1-7/8"
* "U.S. Patent no. 6,161,999 and foreign counterparts thereof. Other patents pending. TOGGLER & typeface
and SNAPTOGGLE are worldwide registered trademarks of Mechanical Plastics Corp."
Dock Mount is
positioned against the
side of your dock
Hold ends of straps
between thumb and
forefinger and pull
toward you until
channel rests flush
behind decking. Slide
plastic cap along straps
with other hand until
flange of cap is flush
.
with decking
- Use a ½ in. diameter drill for hardware provided
- Use a 1/8 in. diameter drill for pilot for ¼ lag bolts
- Use a ¼ in. diameter drill for ¼ machine screws and nuts
Note:
If you have a wooden structure under
your decking at the 2 ¼ inch location,
you may want to consider using a lag
bolt.
Drill ½ diameter holes through Dock Decking Surface
Ensure there are not any electrical or structural
components near the hole you are drilling. Also
check 26 to 32 inches away where you will mount the
second Dock Surface Mount
Secure Surface Mount to Dock
washers and ¼ - 20 screws provided (2)
Snap straps at wall
by pushing side to
side, snapping off
straps level with
flange of cap.
Note:
Secure Dock Surface Mount with
Use 7/16 wrench or socket.
Page 7 of 15