3M X76 - Digital Projector XGA LCD Podręcznik bezpieczeństwa produktu - Strona 11
Przeglądaj online lub pobierz pdf Podręcznik bezpieczeństwa produktu dla Projektor 3M X76 - Digital Projector XGA LCD. 3M X76 - Digital Projector XGA LCD 17 stron. 3m digital projector x76 quick setup
Również dla 3M X76 - Digital Projector XGA LCD: Szybka konfiguracja (1 strony), Arkusz specyfikacji (2 strony), Instrukcja obsługi (18 strony)
Drukuj stronę
Replacing Lamp
The glass lamp used in this projector contains small amounts of mercury and operates at
high pressure and at high temperature and may unexpectedly shatter. Each lamp has a
different lifetime and can fail in different ways, including a rupture with a loud bang or
simply burn out. In the event of a lamp rupture, be sure to follow the instructions.
-
Disconnect power cord when the projector is not in use, during lamp replacement,
and while cleaning.
-
-
Do not attempt to service the projector - there are no user serviceable parts, other
than the lamp cartridge, inside the projector. Contact a 3M authorized service
provider for service.
-
Unplug the projector from the electrical outlet and allow the lamp to cool for 45
minutes before replacing the lamp.
-
Always handle the fragile lamp module with care.
-
Remove the projector from the ceiling or wall mount before replacing the lamp. In
the case of a lamp rupture, small glass particles could fall out when the lamp door
is opened or the projector is tilted.
-
Use care when replacing the lamp module in the event of a lamp rupture - small
glass particles and small amounts of mercury may be present.
-
Ventilate the area where the lamp rupture occurred.
-
Wear safety goggles and gloves when cleaning up ruptured lamp debris.
-
Carefully collect the ruptured lamp debris in a closed container and dispose of
the container and the expired lamp module in accordance with federal, state, and
local regulations.
-
Wash your hands thoroughly after handling ruptured lamp debris.
-
Replace the lamp module when the lamp replacement message appears.
-
Never replace the lamp module with a previously used lamp module.
mercury in the projection lamp:
-
Dispose of lamp cartridge in accordance with applicable federal, state and local regulations.
-
The lamp in this product contains mercury. Dispose of projection lamp in a manner
that is consistent with your local hazardous waste regulations for mercury.
-
For recycling and disposal information, contact your respective governmental
agencies.
In U.S., contact 1-800-328-1371 (3M US) or the Electronic Industries Alliance at
www.lamprecycle.org
In Canada, contact 1-800-364-3577 (3M Canada)
Important Note:
elsewhere besides the lamp. If this happens, contact your local dealer or a service representative.
© 3M 2008. All rights reserved.
WARNING
3M™ Digital Projector X76 Product Safety Guide
11