ETA Systems ETA-PD8A Skrócona instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Dystrybucja zasilania AC ETA Systems ETA-PD8A. ETA Systems ETA-PD8A 12 stron. Ac power conditioner & distribution unit
Drukuj stronęETA-PD8A
AC Power Conditioner & Distribution Unit
FRONT PANEL FEATURES
2
3
5
1
4
1. Unswitched AC Outlet
The 120VAC outlet is always live when the ETA-PD8A power cord is plugged into an AC mains power source. Note: The AC mains
power switch does not affect the Unswitched AC Outlet but it is protected with surge protection circuitry.
2. Power Switch & Cover
To turn the ETA-PD8A On or Off, press the switch to the On or Off position. When in the On position and AC voltage is present the
power LED will illuminate. The ETA-PD8A incorporates a power switch cover to prevent accidental pressing of the power switch.
3. Switched Outlets Active Indicator
This LED will illuminate Blue when the power switch is in the On position.
4. Surge Protect Indicator
The Surge Protect LED is illuminated under normal operating conditions showing that the surge protection circuit is functioning
correctly and the connected equipment is protected from voltage transients. Although the clamping suppression circuit virtually assures
protection from most transient voltage spikes and surges, nature has a way of occasionally creating electrical forces that are beyond
the capabilities of any device to absorb without some degree of damage. In the rare instance that this occurs and the circuit has been
damaged, the Red "Surge Protect" LED indicator will turn off. The ETA-PD8A will shut off permanently until the unit is repaired. Be
advised that activation of this fault condition and the associated repair is not covered under warranty. Note: If the Surge Protect LED is
not illuminated while the unit is powered on, it is important to have all equipment that was connected to that AC Mains Line inspected
for proper operation.
5. Ground Status Indicator
This LED will illuminate Green when the ETA-PD8A has Earth ground connection on the Earth ground pin of the AC Mains power cord.
Note: If there is no Earth ground connection the LED will not illuminate and the AC wall outlet must be repaired by a qualified electrician
before continuing.
1601 Jack McKay Blvd. • Ennis, Texas 75119 U.S.A.
Telephone: 800-321-6699 • Fax: 800-996-3821
– 7 –
ETAsys.com
Specifications are subject to change without notice.