Etabeta electronics PA-6000SV Instrukcja instalacji i obsługi - Strona 5
Przeglądaj online lub pobierz pdf Instrukcja instalacji i obsługi dla Wzmacniacz Etabeta electronics PA-6000SV. Etabeta electronics PA-6000SV 6 stron. Matrix system microphone and panel manual
for adjustment by DIP switch.
Switch the sound source through the front panel button adjustment of the main unit or the touch panel button
of the wall control panel.
DIP switch
1.
Mic /Line Input 1, 2 and 3 each has 2 DIP switches Set in the rear panel and activate the +48V phantom
power condenser microphone.
2.
Set the correct level for the connected input source (MIC or row).
3.
If the connected source is a condenser microphone that requires phantom power, please make sure the
channel of phantom is on.
4.
Make sure to turn off these DIP switches when setting up the amplifier. Any changes on the amplifier's
power supply can cause a loud noise through the system, which can damage the speaker.
5.
The paging microphone and wall control panel DIP switches are used to configure the address to prevent
conflicts.
6.
The paging microphone (PA-6000RM) speaks to the first partition.
7.
1. Press Z1 of the paging microphone (PA-6000RM), the paging indicator will light up, and the digital
display of the host will display C0; press the green CALL button to start talking.
2. If you need to speak in the whole area, you can press the ALL button to quickly select, then press the
CALL button to start speaking. The main panel LEDs all display C0.
3. If the paging microphone (PA-6000RM) control is invalid, please check whether the DIP address
switch dial code on the rear panel is correct, whether it matches, and whether there is a conflict.
4.Third, the control panel (PA-6000SV) use
1. If you need to use the control panel (PA-6000SV) to select the source, use the control panel channel
plus or minus keys to adjust the desired source.
2. If you need to play Bluetooth separately, press the Bluetooth switch button, the panel displays C7,
and the Bluetooth device can play Bluetooth audio. The volume up and down buttons adjust the volume.
3. If the control panel (PA-6000SV) is not displayed, check if the cable is connected correctly. For the
corresponding connection method, please refer to the description of the upper right corner of the rear
panel network port and the control panel (PA-6000SV) bottom box.
4. If the control panel (PA-6000SV) control is invalid, please check whether the DIP address switch
dialing of the rear control panel (PA-6000SV) is correct, whether it matches, and whether there is a
conflict.
5 / 7