Etable ETABLE E1227 Instrukcja bezpieczeństwa i obsługi - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja bezpieczeństwa i obsługi dla Zdalny rozrusznik Etable ETABLE E1227. Etable ETABLE E1227 7 stron. Jump starter power bank
Drukuj stronęWarnings
1. WARNING: When unit is turned on and jump leads are connected, never touch
metal part of clamps through smart cable has short circuit protection.
2. Make sure the correct battery clamps are connected to the correct battery terminal.
3. Ensure the power bank is remove within 30 seconds of the vehicle being started.
4. The power bank shouldn't be dissembled or modified in any capacity.
5. Ensure the jump lead is securely attached to the jump start output port (6). If not
done correctly then this may result in the unit failing.
6. Don't rev the vehicle engine continuously for more than 7 seconds and do not
attempt to jump start after 3 failed attempts within 5 minutes, this can result in the
unit being damaged.
7. Do not leave the power bank unattended when connected to a car battery.
8. Never use the jump starter device in ,on and near explosive chemicals such
as solid, gas or liquid.
9. Do not permit the jump starter device to become wet.
10. Never expose the jump starter device nor any of its components to extreme heat.
11.Never store the jump starter device nor any of its components in a place
in which the temperature exceeds 70° Celsius or 158° Fahrenheit.
12.Only charge the jump starter device using the wall charger and lighter charger
provided for the device. No other chargers should be used.
13.Under very extreme conditions, the battery leakage may occur Using cautiously,
wipe off the liquid on the battery using a dry cloth. Be very careful to avoid
contact with the skin or contact with the eyes. Should you make contact with the
liquid, rinse immediately with clean water and seek proper medical treatment.
14. Only responsible adults should use the power bank and be kept well away from
children.
15. The power bank must be charged in a well ventilated room.
16. After use, always remove jump lead cable from unit immediately after use &
replace protective cover over output port
17.When the jump starter device has ended its usefulness. Please dispose of it
in a way that safeguards and protects the environment.