FLEMING ST1300N Podręcznik - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik dla Pojazd użytkowy FLEMING ST1300N. FLEMING ST1300N 11 stron. Slurry tankers

Drukuj stronę

SHORTENING THE PTO SHAFT.

If the PTO is too short with a tendency

to separate, then it must be replaced

with a longer one.

If the PTO is too long, it should be

shortened using the following method.



Set the tanker at its minimum distance from the tractor. Brake the tractor

and switch off the engine.



Separate the PTO. Attach the female part to the tractor PTO and the male

part to the tanker pump PTO. Ensure that the fixing pins have "clicked" into

position and are engaged.



Keeping the two halves of the PTO parallel line them up side by side. Fig 1.



Match mark where the two halves are to be shortened. Fig 1.



Taking one half of the PTO cut the shield at the mark. Fig 2.



Using the cut off piece as a guide (fig 3) cut the shaft.



Proceed in the same way with the other half of the PTO.



Trim and de-burr the two cut ends of the PTO and clean off all swarf. Fig 4.



Grease the two profiles and join the two halves of the PTO together.



Fit the PTO shaft to the tractor and tanker and check as before that its

length is correct ensuring that minimum overlap advice is observed and

that the PTO does not bottom when turning.

1.9 HYDRAULIC SAFETY

The Slurry Tanker discharge valve and brakes are hydraulically operated. These

safety considerations should therefore be adhered to.

CAUTION The hydraulic system is under high pressure.

Ensure that only high-pressure hoses are used to connect supply to the Slurry

Tankers hydraulic cylinder(s). Check hoses regularly and renew any that are

damaged or worn.

Before working on the hydraulics release the pressure from the hydraulic

Before working on the hydraulics release the pressure from the hydraulic sys-

system and stop the tractor engine.

tem and stop the tractor engine.

When connecting hydraulic rams make sure that the hydraulic hoses are cou-

pled correctly. Pressure should be released from the system both on the tractor

and on the implement side prior to coupling the hoses to the tractor hydraulics.

CAUTION Hydraulic oil forced out under pressure can break the skin and cause

severe injury. In the event of a hydraulic oil leak stop the tractor flow

severe injury. In the event of a hydraulic oil leak stop the tractor flow immedi-

immediately.

ately. DO NOT PUT HANDS NEAR A LEAKING PIPE.

DO NOT PUT HANDS NEAR A LEAKING PIPE.