Etac Swift Mobil-2 Series Podręcznik - Strona 13

Przeglądaj online lub pobierz pdf Podręcznik dla Pomoc w poruszaniu się Etac Swift Mobil-2 Series. Etac Swift Mobil-2 Series 15 stron.
Również dla Etac Swift Mobil-2 Series: Instrukcje regeneracji (4 strony), Podręcznik (13 strony)

Drukuj stronę

Transfers

Over a threshold:

F1. Chair only, put one foot on the wheel.

F2. With user, pull the chair backwards.

In stationary position:

F3. Always lock as many castors as possible when the chair is to be

used in a stationary position.

F4. Out-turned castors improve the chair's stability.

Adjustment

Height:

G1-G7. The height is easily adjusted by inserting the bolt in the

required position. See distances in the technical data section.

Arm supports:

G8. The height of the arm supports and/or width between the arm supports can be adjusted. Loosen the screws, twist the support to the

desired position and retighten the screws. Then loosen and refit the arm support plate in the correct position. Swift Mobil Tilt-2 XL is deliv-

ered with the arm supports mounted in the most inward position (seat width 48 cm).

Tilt angle:

G9. Fit the gas piston in position A to tilt the seat at angles from -5° to 30°

G10. Fit the gas piston in position B to tilt the seat at angles from 0° to 35°

User brake:

G11. When adjusting the brake, the brake pin should be set 18 to 22 mm from the rear wheel for good grip.

Leg support

H1. The assistant can easily raise and swivel the leg supports to the

side for the user to sit down in or get up out of the chair. The foot

supports are detachable.

Tilt function

I1. The assistant can adjust the sitting angle with ease by holding in the handle and tilting to the required position.

Make sure that the wheels are locked if the tilt function is used when the user is sitting in the chair.

English

Transferring:

Assess the risks and take notes. You as a carer are responsible for the

safety of the user. Aids should be used if the transfer is deemed as

risky. Visit www.etac.com for manual transfer aids.

F3-F4. It is important to ensure that the castors are locked and point-

ing outward before carrying out transfers to and from Swift

Mobil-2.

F5-F7. Fold up the arm support on the transfer side of the chair. Carry

out the transfer.

Check that both sides have been adjusted to the same

height as otherwise stability can be reduced. G7. Do not

use the chair if the bolt (orange) is not locked.

H2. Various height adjustment options are available by moving the

locking pin. The leg supports have 6 different height settings.

www.easycaresystems.co.uk

See Figure F

See Figure G

See Figure H

See Figure I